Model BKT Installation, Blower see Figure | Desa (V)VC42N specification

FIREPLACE INSTALLATION

Installing Optional Blower Accessories (Cont.)

FIREPLACE INSTALLATION

Continued

5.Mount speed control box to switch bracket by placing the plastic control shaft forward through the round opening in the switch bracket (see Figure 26).

6.While supporting speed control, secure control shaft with lock nut by pushing and turning lock nut with pliers clockwise until it is tight against front panel. Place control knob provided on shaft.

7.Turn on power to duplex outlet if previously turned off per the warning in column 2, page 16.

8.Plug in blower power cord.

a.If your ﬁrebox is installed as a freestanding unit with an accessory mantel, determine whether the power cord will exit the left side or the right side of the ﬁrebox. Route power cord through exit hole and plug the power cord into a wall receptacle near the ﬁrebox.

b.If your ﬁrebox installation is recessed and/or pre-wired, plug the power cord into the duplex outlet provided. Refer to your ﬁrebox ownerʼs manual for instructions on wiring the duplex outlet.

CAUTION: Never touch the blower wheel while in operation.

9.	Check to make sure that the power cord is completely clear of the
	blower wheel and that there are no other foreign objects in blower
	wheel. Turn blower on and check for operation. Turn blower off
	by turning knob fully counterclockwise before continuing.

Model BKT Installation

Note: When installing the BKT thermostatically-controlled blower, you must ﬁrst secure the thermal switch bracket to the blower if it has not already been factory installed.

1.Place the green ground wire with ring terminal between the bottom hole on the thermal switch bracket and the top ear hole on the blower assembly. Insert the phillips screw into all three pieces and tighten securely (see Figure 28).

2.Connect wire harness and power cord terminals. Connect the blue jumper wire to the blower motor terminal and the right side terminal of the thermal switch. Connect the black wire to the left side of the thermal switch and the white wire to the other remaining blower motor terminal.

Note: The power cord outer insulation sleeve may have to be stripped slightly to allow enough wire length to reach and make all connections. DO NOT trim excessive length away. Just enable enough to make all connections securely.

3.Place the blower against the lower rear wall of the ﬁrebox outer wrapper with the exhaust port directed upward and the thermodisc positioned up near the ﬁreplace bottom. The thermodisc must be oriented near the ﬁreplace bottom as shown in Figure 28 in order to sense temperature and properly operate. The blower will be held in position against the back wall by the magnets incorporated onto the blower housing (see Figure 28).

4.Be certain that all wire terminals are securely attached to ter- minals on blower motor and thermal switch and that the screw for the thermodisc bracket and green ground wire is tight.

10. Peel off the backing paper and stick the supplied wiring diagram

decal on the ﬁrebox bottom approximately 12" in front of the