INSTALLATION
Log Placement for M42 Models
15
INSTALLATION
Continued
LOG PLACEMENT FOR M42/VM42 MODELS
1.Place log 1A on the front left side of grate. Place log 1B on the front right side of the grate. See Figure 29.
2.Place large back log (log 2) onto grate making sure notches rest over grate. Insert peg on back of log 1A into hole on front left of log 2 (see Figure 29).
3.Place log 3 across log 1A and log 2, aligning peg on log 3 with top left hole on log 2 (see Figure 30).
4.Align peg on log 4 with inside left hole on log 2 (see Figure 30). Log 4 will rest on grate fingers as shown in Figure 31.
5.Align peg on log 5 with the inside right hole on log 2 (see Figure 31). Rest the lower part of log 5 on the log 4 and on grate as shown in Figure 32.
6.Align peg at the top of log 6 with outside right hole on log 2. Fit the peg at the lower part of log 6 into the hole on top of log 1B (see Figures 31 and 32).
To enhance the look of the hearth you may optionally place the lava rock provided around the front and sides of the burner pan.
NOTICE: Do not put lava rock inside the burner pan or around the air mixer fitting. Placing lava rock inside the burner pan or blocking the openings of the propane/LP
Log 1A
Log 2
Log 3
Log 4
Log 1A
Figure 30 - Installing Logs 3 and 4
Log 4
Log 2
Log 1B
Log 5
Log 6
Log 2
Log 1B
Figure 31 - Installing Logs 5 and 6
Log 1B
Figure 29 - Installing Logs 1A, 1B and 2 | Figure 32 - Logs Installed for M42 /VM42 Models |
|
For more information, visit www.desatech.com
108795