OPERATING APPLIANCE
Continued
Shutting Off Appliance
Turn gas shutoff valve clockwise to the OFF position.
CURING
LOGS
During the
To ensure proper curing of the logs:
•Ignite a 2" flame and maintain it for 1 hour.
•Burn the logs in consecutive 1 hour periods raising the flame an additional 2" to full flame height for a total of three hours.
OPERATING
INSTRUCTIONS
FOR GA9050A
Note: Operation instructions for GA9150A Remote Ready Valve/Pilot Kit will be included with the kit.
1.STOP! Read the safety information, page 10.
2.Make sure equipment shutoff valve is fully open.
3.Press in and turn control knob clockwise to the OFF position.
4.Wait five (5) minutes to clear out any gas. Then smell for gas around log set and near floor. If you smell gas, STOP! Refer to the National Fuel Gas Codes, ANSI Z233.1/ NFPA 54, Section 5.3, Air for Combustion and Ventilation. If you donʼt smell gas, go to the next step.
5.Turn control knob counterclockwise to the PILOT position and press in. Keep control knob pressed in for five (5) seconds. Note: You may be running this log set for the first time after hooking up to gas sup- ply. If so, the control knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system.
•If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.
6.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the rear of the front burner. If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match.
7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
Note: If pilot goes out, repeat steps 3 through 7.
8.Turn control knob counterclockwise to the ON position. Burner should light. If burner does not light, call a qualified service person.
Control Knob
Ignitor Pilot
| ON |
| OFF |
|
| FROM "PILOT" POSITION |
| ||
On | SLIGHT PUSH TO | Off | ||
| PULL PUSH | |||
|
| TURN OFF |
| |
ON OFF FROM "PILOT" POSITION SLIGHT PUSH TO TURN OFF PULL PUSH | TO LIGHT | ON OFF FROM "PILOT" POSITION | ||
TO LIGHT | SLIGHT PUSH TO TURN OFF PULL PUSH TO LIGHT | |||
Figure 12 - Ignitor and Control Knob | ||||
| Thermocouple | |||
Pilot |
|
|
|
|
Burner |
|
|
|
|
Figure 13 - Thermocouple and Pilot | ||||
TO TURN OFF GAS |
| |||
TO APPLIANCE |
|
| ||
Shutting Off Appliance |
|
|
|
|
1.Turn control knob clockwise to the PILOT position.
2.Press in and turn control clockwise to the OFF position.
Shutting Off Burner Only (pilot stays lit) | |
Turn control knob clockwise | to the |
PILOT position. |
|
www.desatech.com | 11 |