Desa M42EP LOG Placement for M36E, M36EP, VME36 and VM36EP Models, Log Notch Log 3 Log Notches

Page 14

INSTALLATION

Continued

Grate

Pan and Ember

0.5"

Material

0.5"

 

Burner Pan

Figure 22 - Pan and Ember Material

Clearances

LOG PLACEMENT FOR M36E, M36EP, VME36 AND VM36EP MODELS

1.Place small front right log (log 1) on right front of grate as shown in Figure 23.

2.Place large back log (log 2) onto grate mak- ing sure notches rest over grate as shown in Figure 23.

3.Place log 3 into notch on log 2, resting the front end on top of log 1 (see Figure 24).

4.Place the upper end of log 4 into the notch on log 2 as shown in Figure 24. Rest the lower end of log 4 onto the middle grate finger as shown in Figure 25.

5.Place the upper end of log 5 into notch on the left of log 2 (see Figure 25). Rest the lower end of log 5 on the grate as shown in Figure 26.

6.Insert the lower end of log 6 between the first two grate fingers as shown in Figure 26 and position the upper end of log 6 into the notched area on the front of log 2 as shown in Figure 26.

As an option to enhance the look of the hearth, you may place the lava rock provided around the front and sides of the burner.

Log 2

Notch

Log 1

NOTICE: Do not put lava rock inside the burner pan or around the air mixer fitting. Placing lava rock inside the burner pan or blocking the openings of the pro- pane/LP air-mixer could cause performance problems.

Log 4

Log 3 Log 2

Notches

Log 1

Figure 24 - Installing Logs 3 and 4

 

Log 5

Log 6

Notch

 

Log 4

Notch

Figure 25 - Installing Logs 5 and 6

Figure 23 - Installing Logs 1 and 2

Figure 26 - Logs Installed for M36E, M36EP, VME36 and VM36EP Models

14

www.desatech.com

108796-01K

Image 14
Contents For Your Safety Table of Contents Safety Information High traffic areas Windy or drafty areasBefore YOU Begin UnpackingIntroduction Possible Locations for Installing Appliance Selecting LocationProduct Specifications M36EB,H M42EB,HMantel Clearances and Wall PRE-INSTALLATION PreparationClearances DetailsRough Opening for Installing Wall FramingVent Piping Starter Collar Transition Pipe Vent Collar Venting InstallationInstalling Transition Pipe and Starter Collar Typical B-Vent Configuration Roof PitchChecking for Proper Venting InstallationWall Switch Installation VM36EB,H GAS Line HOOK-UPM42EPB,H Ember and PAN Material Placement Log Notch Log 3 Log Notches LOG Placement for M36E, M36EP, VME36 and VM36EP ModelsGrate Pan and Ember Material Burner Pan LogLog Notches LOG Placement for M42E, M42EP, VME42 and VM42EP ModelsNotch Log Log 2A Log 2B Log Notch Log 2BAppliance Enclosure Installing Optional Glass Door AccessoryCombustion AIR KIT Model AK4 Optional Clip Screw Side Front Opening Vent DamperSpring Partially Opened DoorLighting Instructions For Your Safety Read Before LightingOperating Fireplace EquipmentTo Turn OFF GAS To Appliance Pilot AssemblyInspecting Burners Optional Remote OperationTechnical Service Cleaning MaintenanceService Hints Replacement PartsWiring Diagram Pilot Burner Pilot Gas LineTroubleshooting Observed Problem Possible Cause RemedyGas leak. See Warning Illustrated Parts Breakdown ModelsParts List DescriptionDescription QTY Logsets for Models 108723-01M42B,H, M42PB,H, VM42B,H and VM42PB,H Accessories 108796-01K 108796-01K Limited Warranty VENT-FREE Firebox Warranty InformationKeep this Warranty