Desa GL36STP, GL36STEP installation manual LOG SET Placement, Fireplace Facing

Page 10

FIREPLACE

INSTALLATION

Continued

To install:

1.Remove gas line cover plate from applianceʼs outer surround at the location to be used.

2.Remove insulation from inside the gas line conduit sleeve.

3.Run gas line through sleeve.

4.Prepare incoming black iron gas line with Teflon tape or pipe joint compound. (Check local codes as to the use of Teflon tape.)

CAUTION: Compounds used on threaded joints of gas piping shall be resistant to the action of Liquefied Petroleum (LP or propane) and should be applied lightly to ensure excess sealant does not enter the gas line.

5.Connect incoming gas line to regulator. Secure all joints tightly with wrench, but do not over tighten. If a flexible gas line is used, take care not to kink the connector.

6.Re-pack insulation in and around the conduit sleeve and flexible gas line.

WARNING: All gas piping and connections must be tested for leaks after the installation is completed.

After ensuring that the gas valve is on, apply a commercial leak detection solution to all con- nections and joints. If bubbles appear, leaks can be detected and corrected.

Do not use an open flame for leak testing and do not operate any appliance if a leak is detected.

Key

Shutoff

Valve

 

Extension

Typical Exterior Wall Gas

Shutoff Installation

Figure 15 - Typical Exterior Wall Gas Shut-Off Installation

LOG SET PLACEMENT

Carefully remove log set from packaging. Place the two bottom logs over grate and align with pins. Place three loose logs, or twigs, onto alignment pins on two bottom logs (see Figure 16).

Bottom Logs

Top Logs (Twigs)

Figure 16 - Log Placement

FIREPLACE FACING

Any non-combustible material may be used for facing (glass, tile, brick, etc.) as long as the proper clearances are adhered to and the fireplace open- ings are not blocked or obstructed in any way. See Clearances, page 6, and Figure 17 on page 11.

Use only heat-resistant, noncombustible mortar or adhesive when securing facing material to the front of the fireplace.

10

www.desatech.com

55173-F

Image 10
Contents For Your Safety AspenTable of Contents Safety Information High traffic areas Windy or drafty areasDimensions Before YOU Begin IntroductionSelecting Location Cause a Fire HazardClearances Fireplace InstallationMantel Clearances Framing Vent Pipe InstallationType Vent Not Supplied Strap Fasten with #6 Screw or Bolt Electronic Models GL36STE/EP Optional Outside AIR KIT Model AK-4Millivolt Models GL36ST/STP GAS Supply Testing GAS Line HOOK-UPLOG SET Placement Fireplace FacingBurner Flame Adjustment Pilot Assembly AdjustmentMantels Installing Glass Door Optional Glass DoorOperating Fireplace Millivolt Models For Your Safety Read Before LightingGas Control Knob Position Indicator Lighting InstructionsTo Turn OFF GAS To Appliance Electronic Models For Your Safety Read Before LightingPilot Burner Thermopile Ignitor Specifications Cleaning MaintenanceTechnical Service GL36ST, GL36STEWiring Diagrams Millivolt Wiring DiagramObserved Problem Possible Cause Remedy TroubleshootingMillivolt System Sories, Electronic Ignition SystemValve is OFF Supply Construction debris clog To regulator valve. No milReplacement Parts and Accessories Limited 2-YEAR Warranty