OWNER’S MANUAL
INSTALLATION
Continued
4.Apply thread sealant compound to the 3/8" male threads of the burner inlet fitting. Thread the manifold block (see Figure 15) onto the burner inlet fitting. Use the bottom hole of the block.
5 . Apply thread sealant to the 1/8" brass pipe nipple and thread it into the mani- fold block (see Figure 15). Tighten with a 7/16" wrench.
6.Slip the air restrictor over the 1/8" pipe nipple. Apply thread sealant to the male threads and install the rear burner in- jector provided with the GA9003 (see chart on page 7) onto the fitting. Tighten with a 9/16" wrench. Proceed with step 7, page 9 in Hearth Kit As- sembly and Installation.
Rear Burner Nozzle
Air Restrictor
Pipe
Nipple
Front
Burner Burner Inlet
Fitting
Manifold
Block
Figure 15 - Kit Assembly
Injector for
Natural Gas 
BURNER
INLET
FITTING
Figure 16 - Burner Inlet Fitting with Injectors
Changing Pilot Orifice
The pilot is provided with a natural gas orifice installed. For propane/LP gas you must remove it and replace it with an pro- pane/LP orifice. The hardware kit contains an propane/LP orifice with a red stripe for converting the pilot.
1.Gently loosen and remove the pilot line connection from the bracket (see Figure 17).
2.Replace the injector (see Figure 17) with the propane/LP pilot injector with the red stripe.
3.Replace and tighten the pilot line to the bracket.
4.Continue with step 3 under Natural Gas Installation, page 10.
Pilot
Injector
Figure 17 - Installing Propane/LP Pilot Orifice
TESTING BURNER FOR LEAKS
1.Generously apply soapy solution to all connections.
WARNING: Never check for gas leaks with open flame.
2.Light the burner with the shutoff valve no more than half open and holding a match slightly in front of the pan (see Lighting Instructions, page 12).
3.Inspect all connections for bubbles, raw gas odor, or flame from any area other than the burner (leaks). If leaks are de- tected, shut off the gas valve immedi- ately. Tighten, or reassemble the loose connection(s) using pipe joint com- pound until burner system is leak free.
4.When the burner is tested and leak free, observe the individual tongues of flame on the burner. Note: The burner design includes more ports on the outside of the bar. Make sure that all ports are clear and producing flame evenly across the burner. If any ports appear blocked, clear them by removing the burner manifold and reaming the ports with a modified paper clip or other suitable tool.
5.When finished testing, turn the gas shutoff valve OFF to extinguish all flames.
ADDING PAN MATERIAL
1.Open the bag of ash bed material (ver- miculite) and spread it evenly across the burner pan to the top. You may over- flow the front and sides of the pan to cover the entire pan and connecting hardware.
2.Open the glowing embers and evenly cover the ash bed material (vermicu- lite) in the burner pan.
901847 | 11 |