Calphalon 8353 owner manual Manual Lighting of the Grill

Page 19

Manual Lighting of the Grill

·Open Hood before lighting the grill to prevent an explosion from gas build-up.

·Always inspect the gas hose and regulator assembly before each use. If the hose is cut, damaged, or showing signs of excessive abrasion or wear, do not use the LP gas grill. Contact the manufacturer, as the hose must be replaced

with an assembly specified by the manufacturer prior to further use of the LP gas grill.

How to manually light your LP gas grill

1)Open Hood and Control Panel Cover.

2)Important: The LP gas cylinder valve must be opened first before turning the control knobs on the grill. Turn the LP cylinder valve counter- clockwise until it stops.

3)Using the match Wire Holder (Item 25), light a match and insert it through the match-lighting hole underneath the left side table on the grill Body. Hold lit match near burner(See figure below).

4)Locate the control knob that corresponds to the match lighting hole that you are using. Push in and turn the control knob counter-clockwise until a click is heard.

WARNING: If the burner fails to ignite after following the above procedure, turn all the knobs

to

the “off” position and close the valve on the LP gas cylinder. Wait five minutes and repeat all of the above manual lighting procedures. If the grill still fails to light, see the Troubleshooting page.

5) Light the remaining burners from left to right by turning the control knob counter-clockwise. Your grill has a crossover ignition system that allows the burners to light successively off one another. Confirm each burner is lit before

lighting another burner.

6)After ignition, burners should be burned at the “high” position for 3-5 minutes in order to preheat the grill. This process should be done before every cooking session. The hood should be closed during preheating.

WARNING: If a burner goes out during the cooking

cycle, turn all knobs to the “off” position and close the valve

on the LP cylinder. Open hood and wait five minutes before attempting to relight the grill. Always leave Control Panel Cover open during use to prevent excess heat buildup

and damage to your grill.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Use Care Manual For Your SafetyImportant Safeguards Never use the grill without the Grease Tray in place IMPORTANT! Please Read Assembly InstructionsTM Calphalon Grill Parts List Unpacking the Grill Assembly InstructionsAssemble the Pedestal Assemble the Grill Body StepDo not leave grill unattended until Bolts are secured Install Heat Shield Assemble Handle and Side Tables Install Grease TrayAssemble Side Tables Adjust Tab if greater than 3/16 Install BurnersAttach LP Cylinder to Grill Install Ceramic Briquette TRAYS/ Cooking GridsView a How to perform a leak testGAS, CYLINDER, Hose Regulator Information Connecting/ Disconnecting LP Gas Cylinder to GrillLP Gas Cylinder Precautions Before Using Your LP GAS GrillSelecting a Location Operating the LP GAS Grill LeakTestingPreparation Before Cooking Lighting the Grill Using the Integral Ignition SystemConfirm each burner is lit before lighting another burner Manual Lighting of the Grill Grill Cooking Care and MaintenanceCheck Your Flame End of Cooking Session Turn off Your LP Gas GrillHow to clean porcelain coated cast iron burners Burner MaintenancePorcelain coated Cooking Surfaces Burners will not light Possible Cause Solution ProblemUsing the igniter Using a matchFlames blow out Problem Possible Cause SolutionLP not Supplied with Grill Important NoticeCalphalon Grill Limited Warranty
Top Page Image Contents