Porcelain coated Cooking Surfaces

CARE AND MAINTENANCE

(Continued)

Regularly clean your LP gas grill between uses and espe- cially after extended periods of storage. Ensure the grill and its components are cool before cleaning. In order to extend the life and maintain the condition of your grill, we strongly recommend that the unit be covered when stored outside for any length of time, especially during the winter months.

Most residue on the Cooking Grids can be cleaned with a baking soda and water solution. For stubborn stains, use a non abrasive scouring powder. Do not use steel wool or other like cleaning products on the porcelain coated or stain- less steel surfaces. This will scratch the surface.

Burner Maintenance

·Check the LP gas grill for gas leaks and burner obstructions before each use.

·Always turn off the LP gas cylinder at the

LP cylinder valve when not in use. Allow grill to cool before handling parts or cleaning.

Provided that the burners are operating correctly, in normal usage, burning off the residue after cooking will keep the burners clean. The burners should be removed and cleaned annually, or whenever heavy build-up is found, to ensure that there are no signs of blockage (debris, insects) in either the burner portholes, the primary air inlet, or the neck of the cast iron burners. (See burner cleaning instructions below)

How to clean porcelain coated cast iron burners

1)Make sure the LP cylinder and Grill control knobs are turned off, and that the Grill has cooled completely.

2)Carefully remove Cooking Grids and Ceramic Briquettes.

3)Remove the burners, by first removing cotter pin from each burner peg located at rear end of burner. (See Figure below)

4)Remove each burner from the grill.

5)Clean burners. Use a pipe cleaner to clear obstructions from the burner holes and inlet hole. A brass wire brush can be used to remove corrosion and food particles from the burner surfaces. (See Figure below) Verify that there are no insects or insect nests blocking the inlet hole.

Remove Cooking Grids and ceramic Briquette Trays.

Step 1. Turn the LP Cylinder han- dle clockwise until it stops.

Note: It is normal for surface rust to be present on the burners.

6)Once all burners are cleaned, place each burner back into grill and reinstall cotter pin. Note: When refitting the burners, be careful to check that they are positioned correctly. (Refer to Step 7 of Assembly Instructions for reinstallation)

7)Assemble Ceramic Briquette Trays and then Cooking Grids.

Step 3. Remove cotter pins and burners from grill. (Follow steps

3rd - Slide burner back

2nd - Lift rear of burner up

1st - Pull cotter pin out

Step 5. Use a pipe cleaner to clear obstructions from all burner holes. A brass wire brush can be used on the burner surfaces to remove corrosion.