Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of bumer assembly or if you have trouble igniting grill.
1.Turn gas off at control knobs and LP tank,
2.Remove cooking grate and
3.Remove grease can from beneath grill. Beneath grill bottom, disconnect ignitor wire from electrode.
4.Remove screw holding collector box. Notewhich hole on collector box used for attaching to burner. Remove collector
box and clean ceramic portion of electrode with rubbing alcohol and cloth.
5.Under control panel, disengage burner springs from burner tubes. Do not remove springs from valves.
6.To remove burner, slide backwards, lift up and out of grill.
7.Clean outside of burner with soap and water. Lay burner upside down on fiat surface. Force a stream of water through tubes. Make sure water comes out of all burner holes. Open clogged holes with a thin wire. Shake out excess water and examine holes. Due to normal wear and corrosion, some holes may become enlarged. If any largecracks or holes are found replace burner.
,If grill is to be stored, coat burner lightlywith cooking oil. Wrap in protective cover to keep insects out. If not storing grill after cleaning, hold burner at an angle and insert into grill bottom.
9.After cleaning, insert electrode into hole in grill bottom. Reattach collector box to burner with screw. Be sure to use correct hole.
10.Place end of spring into hole on underside of burner tube, as before, to secure burner. See figure A.
VERY IMPORTANT: Burner tube must engage valve opening as shown in figure A.
11.Reattach ignitor wire to electrode.
12.Reposition
13.Before cooking again on grill, follow "Burner Flame Check".
Burner
Collector..-_ '_
Box
•Do not use charcoalwith this grill.
Ignitor
Wire
463845504°23