Kenmore 90113 manual Qty.4, 7mm lock

Page 22

9	This step requires two people to lift and position grill head onto cart.
	Remove tie wrap holding regulator hose to bottom of grill head. Remove packing material. Loosen tie
	wrap holding ignition wires to bottom of grill head. Retain tie wrap to bundle ignition wires together.

Carefully lower the grill head onto the cart, aligning slots at bottom of grill head with posts on cart side panels.

Regulator hose must hang inside the cart. Grill head must face open side of cart.

Grill head

Regulator hose

Post

10	Secure front brace in upper hole with one 1/4-20x1½” screw, 7mm lock washer and 7mm ﬂat washer,
	shown A. Secure upper back panel in lower hole with one 1/4-20x1½” screw, 7mm lock washer and 7mm

ﬂat washer, shown B.

Only left side shown; repeat above instructions for right side.

1/4-20x1½” screw						A
1/4-20x1½” screw								1/4-20x1½” screw
Qty.4	Upper back							1/4-20x1½” screw
	Upper back
	panel	B
		B
7mm lock washer		7mm ﬂat		7mm lock
7mm lock washer		washer		washer
Qty.4					7mm ﬂat			7mm lock
					washer			washer
								washer

	7mm ﬂat washer	1/4-20x1½” screw
	Qty.4	1/4-20x1½” screw
	Qty.4

22 • 466224411

Image 22

Contents Kenmore/MD ModelSafety Symbols Installation Safety PrecautionsProduct Record This Grill is for Outdoor Use Only Personal injury and/or property damage LP Liquefied Petroleum GasLP Tank Filling Use only LP Tanks equipped with this type of valveIt will defeat the Safety Relief Valve feature Connecting Regulator To The LP TankFor your safety LP Tank ExchangeLeak Testing Valves, Hose and Regulator Turn all grill control knobs to OFFApartment Dwellers Safety TipsFor Safe Use of Your Grill and to Avoid Serious Injury Open lid during lightingSideburner Match Lighting Sideburner Ignitor LightingBurner Flame Check Firebox Cleaning the Burner AssemblyStoring Your Grill Carefully replace burnersIndirect Cooking Food SafetyHow To Tell If Meat Is Grilled Thoroughly Indirect Cooking InstructionsSteamed Corn-on-the-Cob Ingredients Kenmore Exclusive Steamer FeatureSteamer Recipes DirectionsSteamed Scallops Steamed Asparagus IngredientsParts List Parts Diagram Assembly Cart right side panel Right Possible before fullyTightening screws Panel7mm ﬂat washer At washer Qty.2 Tank exclusion wire shelf #8-32x3/8 4mm ﬂat washer, shown B #8-32x3/8 screw 4mm lock washer Screw #8-32x3/8 screw 4mm lock washer 4mm ﬂat washer20x1/2 screw 7mm lock washer 7mm ﬂat washer Qty.27mm ﬂat washer Qty.1 7mm lock washer Qty.1 Lower back panel Shown a Lower back panel Front braceQty.4 7mm lockLeft side panel Tie wrapModule + CapLarge ﬂat washer Qty.2 Self-tapping screw Valve stem Sideburner Ignitor wireControl knob Side burner7mm lock washer Repeat for left door assembly PinGrease tray Grates so that side with four corner feet faces downCylinder screw at rear of cart Steamer Tray Use Handle ToolTroubleshooting Emergencies Possible Cause Prevention/SolutionElectronic Ignition Troubleshooting Electronic Ignition Section466224411