Kenmore 90113 manual Tie wrap, Module, Left side panel, + Cap, flat washers

11

Inside of cart, connect the five wires from burner electrodes into the back of Electronic Ignition module, positions 1 - 5, shown A.

Connect the two wires [(a) and (b)] from switch wiring harness into the back of Electronic Ignition module, shown A.

Note: Switch terminals are larger than electrode terminals and should only be installed in locations (a) and (b).

Remove the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left side panel with the nut, shown B.

Insert AA battery into ignition module, negative (-) end first. Then put on the cap, shown C.

A

Tie wrap

(a)

1

4

2

B	Electronic ignition
	module
	Nut

Left side panel

NOTE: Wires omitted for clarity of illustration.

C Left side panel

3 (b) 5

Electronic ignition module

-

AA battery

+ Cap

12	Attach towel bar to right side extended shelf using two 1/4-20x1/2” screws, 7mm lock washers and 7mm
	flat washers.

Right side fascia

1/4-20x1/2” screw

Qty.21/4-20x1/2” screw

screw 7mm lock 7mm flat

washer washer

7mm lock washer		Towel bar
Qty.2	Extended shelf

7mm flat washer Qty.2

466224411 • 23