Kenmore 90113 Control knob, Valve stem Sideburner, Side burner, Bezel, Drip pan, Ignitor wire

15	First, remove the two screws and lock washers attached to the sideburner valve bracket. Position
	sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center

hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Attach using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia, so that valve stem is centered in the large hole. Attach using two #8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Note: Use left and right

holes on fascia to Screws and Washers attach valve bracket removed from valve bracket

#8-32x3/8” screw		4mm lock washer
Qty.2		Qty.2
	Note: Use upper and lower
		holes on fascia to
Control knob		attach bezel
	#8-32x3/8” screw

4mm lock washer

Sideburner fascia

Valve stem	Sideburner
	valve bracket

Side burner	Valve stem
bezel

Install bezel with “OFF” at top.

OFF

Hi

8a16	Insert sideburner tube through hole in bottom of sideburner shelf. The stud on bottom of burner fits into
	small hole at rear of sideburner drip pan, shown A.
	Under sideburner shelf, secure burner to sideburner drip pan with one Wing nut. Untie sideburner ignitor

wire which was tied to metal hose. Attach this wire to electrode. Make sure burner tube engages sideburner valve, shown B.

A

sideburner burner

Wing nut

Qty.1

B

electrode

sideburner drip pan

	burner
sideburner	tube
	valve
drip pan	hose
Wing nut	MetalBurner tube engages

ignitor wire sideburner valve

26 • 466224411