Leak Testing Valves, Hose and Regulator
Hold coupling nut and regulator
as shown for proper connection
to LP tank valve.
6.Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the
NOTE:
If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to complete the connection, do not use this regulator!
Call
1.Turn all grill control knobs to OFF.
2.Be sure regulator is tightly connected to LP tank.
3.Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection.
Correct before proceeding by calling customer services for replacement parts at
4.Brush soapy solution onto areas where bubbles are shown in picture below:
Never remove threaded
orifice at end of valve.
DANGER
•Do not insert any tool or foreign objects into the valve outlet or safety relief valve. You may damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.
•If a leak is detected at any time, STOP and call the fire department.
•If you cannot stop a gas leak, immediately close LP tank valve and call LP gas supplier or your fire department!
5.If “growing” bubbles appear, there is a leak. Close LP tank valve immediately and retighten connections. If leaks cannot be stopped do not try to repair. Call customer services for replacement parts at
6.Always close LP tank valve after performing leak test by turning hand wheel clockwise.
WARNING
•Never attempt to attach this grill to the
•Do not use grill until
6 • 466224411