Char-Broil 463250811 manual Valve stem Sideburner valve bracket Side burner bezel

18 First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Note: Use left and right holes on fascia to attach valve bracket

Screws and Washers removed from valve bracket

Note: Use upper and lower holes on fascia to attach bezel

Control knob #8-32x3/8” screw

4mm lock washer

Sideburner fascia

Valve stem

Sideburner valve bracket

Side burner bezel

Note: Make sure set the bezel with longer slot at the top

198a Insert sideburner burner into left shelf. The stud on bottom of burner fits into rear small hole in sideburner drip pan on shelf, shown A. Secure burner to sideburner drip pan with one Wing nut, shown B. Under sideburner shelf, attach sideburner ignitor wire to electrode. Make sure burner tube engages sideburner valve, shown C.

B

Wing nut

C

tube burner

electrode

ignitor wire

sideburner drip pan

sideburner burner

valve

sideburner drip pan

A

26