Char-Broil 463250811 manual Reverse instructions from step, Through to re-install socket

Page 10

Grill Halogen Light

LIGHT OPERATION INSTRUCTIONS

1.Make sure light switch on the control panel is in the “OFF” position.

2.Connect light plug to an extension cord, then put the extension cord plug into the outlet on the wall.

3.Turn the light switch to “ON”.

WARNING

˙Keep any electrical supply cord away from any heated surface.

˙Use the shortest length extension cord required. Do not connect 2 or more extension cords together.

1.

2.

 

3.

 

ON

 

 

 

ON

 

OFF

 

 

 

OFF

 

 

 

 

 

 

 

 

 

 

 

 

Light plug

Extension cord, for out door use

Bulb Replacement

Make sure light switch on the control panel is in the “OFF” position and adapter plug is disconnected from outlet.

Step 1

Step 2

Step 3

Release the screw securing the light socket.

 

 

 

 

Take out the socket and remove the lens.

 

Loosen the two screws which are

 

 

 

 

 

 

 

 

 

 

locking the bulb.

 

 

 

 

 

 

 

 

 

Step 4

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Step 5

 

 

 

 

 

 

 

 

 

 

 

Reverse instructions from step 3

 

 

 

 

 

Bulb Specification

 

 

 

 

through step 1 to re-install socket.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Bulb Type: Halogen

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Wattage: 10 W per bulb

 

 

 

 

 

 

 

 

 

 

 

 

Voltage: 12 V

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Pull out the bulb and replace

 

 

 

 

 

CAUTION

 

 

 

 

 

 

 

 

Take care not to touch the bulb with your bare fingers.

 

 

with a new bulb.

 

 

 

 

 

 

 

Touching bulb with your skin can leave a film on the

 

 

 

 

 

 

 

 

 

 

bulb that causes it to burn out quickly.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Continued on next page

 

 

 

 

 

 

 

 

 

 

 

 

10

Image 10
Contents Estimated assembly time 30 minutes Date PurchasedINSTALLER/ASSEMBLER Installation Safety Precautions California PropositionUL listed Overfill Protection LP Liquefied Petroleum GasLP Cylinder Filling Only LP cylinders equipped with this type of valveUseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF For Safe Use of Your Grill and to Avoid Serious Injury Main Burner Ignitor LightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckCleaning the Burner Assembly Storing Your GrillReverse instructions from step Through to re-install socketBulb that causes it to burn out quickly Cleaning the Lens Limited Warranty Parts List Parts Diagram Assembly One 1/4-20x1/2 screw Lower back panel Cart Left Tank heat shield Light wire harness Fiber washer 20x1½ screw Upper back Page #8x3/8 self-tapping screw Large flat washer 20x1½ screw Washer #10-24x3/8 screw Nut Valve stem Sideburner valve bracket Side burner bezel Right door Drawer front panel Assembled warming rack Regulator Burner Front Firebox Carryover Tube Hitch PinNatural Gas Bezel Screws Bezels Valve Stem Sideburner Grate Wingnut Orifice Orifice Removal Tool Valve80007894 Screws Bezel Valve Stem Natural Gas BezelValve Sideburner Outdoor Stove & Griddle Conversion Screws Bezel Valve Stem Natural Gas Bezel 80007886 Natural Gas Hose Conversion To the grill. Direction of gas flow is indicated on Connecting Your Grill to the Natural Gas SourceSocket Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA