Char-Broil 463250811 manual Fiber washer 20x1½ screw Upper back

12

Secure front brace in upper hole with one 1/4-20x1½”screw and fiber washer. Secure upper back panel in lower hole with one 1/4-20x1½”screw and fiber washer.

Only left side shown for assembly, repeat above steps for right side.

Fiber washer

1/4-20x1½” screw

Upper back	Fiber washer
panel

1/4-20x1½” screw

13

Inside of the cart, connect the wires from burner electrodes into the back of Electronic Ignition module. Total (5) connections. Connect the two wires [(a) and (b)] from switch wiring harness into the back of Electronic Ignition module. Total (2) connections, shown A.

Note: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b). Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel

with the nut, shown B.

Insert AA battery into ignition module, negative (–) end first. Then put on the cap, shown C.

A

Tie wrap

1	(a)	3
2
		4

B	Nut
Electronic ignition
module

Right side panel

NOTE: Wires omitted for clarity of illustration

C Right side panel

(b) 5

Electronic ignition module

-

AA battery

+ Cap

21