Char-Broil 463210510 Leak Testing Valves, Hose and Regulator, Turn all grill control knobs to OFF

Page 10

Hold coupling nut and regulator as shown for proper connection to LP cylinder valve.

6.Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools.

NOTE:

If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to complete the

connection, do not use this regulator!

DANGER

•Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.

WARNING

•Outdoor gas appliance is not intended to be installed in or on a boat.

•Outdoor gas appliance is not intended to be installed in or on an RV.

•Never attempt to attach this grill to the self-contained LP gas system of a camper trailer or motor home.

•Do not use grill until leak-tested.

•If a leak is detected at any time, STOP and call the fire department.

•If you cannot stop a gas leak, immediately close LPcylinder valve and call LP gas supplier or your fire department!

10

Leak Testing Valves, Hose and Regulator

1.Turn all grill control knobs to OFF.

2.Be sure regulator is tightly connected to LP cylinder.

3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding.

4.Brush soapy solution onto areas circled below, or other similar fittings on your grill.

 

 

 

 

 

 

 

 

NOTE: Your grill

 

 

NOTE: Sideburner

 

may NOT be

 

 

shelf fascia not

 

equipped with a

 

 

shown for clarity.

 

sideburner.

 

 

 

 

 

 

5.If “growing” bubbles appear, there is a leak. Close LP cylinder valve immediately and retighten connections. If leaks

cannot be stopped do not try to repair. Call for replacement

parts.

6.Always close LP cylinder valve after performing leak test by turning hand wheel clockwise.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Estimated assembly time 35-40 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLava Rock / Briquettes TemperatureFirst Time Use Pre-Heating Your GrillIndirect Cooking Food SafetyDirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Routine Care Why Clean?General Cleaning Storing Your GrillLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling LP Cylinder Leak Test For your safetyDo not use household cleaning agents. Damage to gas Nipple has to be centered into the LP cylinder valveConnection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckTurn gas OFF at control knobs and LP cylinder Cleaning the Burner AssemblyStoring Your Grill Very Important Burner tubes must reengage valveLimited Warranty Disclaimer of Implied Warranties and Limitation of RemediesKey Qty Description Parts ListNot Pictured Parts Diagram Assembly Upper Front panelQty Tank Retainer ,Wire Form Hitch Pin Qty #10-24x1/2 Machine ScrewQty 20x1/2 Machine Screw Page Sideburner Valve Ten t Page Hose Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Page Warranty Registration Department Box Columbus, GA
Top Page Image Contents