Char-Broil 463210510 manual Qty #10-24x1/2 Machine Screw, Qty Tank Retainer ,Wire Form Hitch Pin

Page 19

5

Stand cart upright.

Attach cylinder insulation board to cart back brace with #10-24x1/2" screws.

Cylinder Insulation Board

Qty: 3

#10-24x1/2"

Machine Screw

6

Place grease tray to the cart assembly as shown.

Insert tank retainer to the holes from the bottom shelf. Attach with a hitch pin.

Grease Tray

Qty. 1

Tank Retainer,Wire Form

1” Hitch Pin

 

19

Image 19
Contents Date Purchased Estimated assembly time 35-40 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsPre-Heating Your Grill TemperatureFirst Time Use Lava Rock / BriquettesRotisserie Cooking Food SafetyDirect Cooking Indirect CookingUsda Recommended Safe Minimum Internal Temperatures Storing Your Grill Why Clean?General Cleaning Routine CareLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling Nipple has to be centered into the LP cylinder valve For your safetyDo not use household cleaning agents. Damage to gas LP Cylinder Leak TestConnection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF Open lid during lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting SDo not lean over grill while lightingBurner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match LightingVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinderDisclaimer of Implied Warranties and Limitation of Remedies Limited WarrantyKey Qty Description Parts ListNot Pictured Parts Diagram Assembly Front panel UpperQty #10-24x1/2 Machine Screw Qty Tank Retainer ,Wire Form Hitch PinQty 20x1/2 Machine Screw Page Sideburner Valve Ten t Page Hose Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Page Warranty Registration Department Box Columbus, GA