Char-Broil 463210510 manual Upper, Front panel

Page 18

3


Attach upper and lower front panel to	cart with 1/4-20x1/2" screws, 7mm	Flat Washer and
7mm Lock Washer on each side.	panel with #10-24x1/2" screws and	#10-24 hex nuts.
Attach upper front panel to lower front	panel with #10-24x1/2" screws and	#10-24 hex nuts.
	Upper		Front panel
	Upper

Qty: 8	Qty: 2
1/4-20x1/2"	#10-24x1/2"
Machine Screw	Machine Screw

Qty: 8

7mm Flat Washer

Lower	Front panel

Qty: 8

7mm Lock Washer

Qty: 2

#10-24 Hex Nut

4

Qty. 1

1” Hitch Pin

Qty: 4

Axle Washer

Turn assembly upside down.

Insert axle rod into wheel, axle washer, legs and other wheel. Attach with a hitch pin.

Push leg extenders into right legs.

Attach back brace to cart with 1/4-20x1/2" screws,

7mm Flat Washer and 7mm Lock Washer on each side.

Leg Extenders

Qty: 4

7mm Flat Washer

	Qty: 4	Hitch	Pin
	7mm Lock Washer		Axle Rod
	7mm Lock Washer	Axle	Washer
		Axle	Washer

Wheel

Qty: 4

1/4-20x1/2"

Machine Screw

"Cone" side of wheel against leg

Back brace

18

Image 18

Contents Estimated assembly time 35-40 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLava Rock / Briquettes TemperatureFirst Time Use Pre-Heating Your GrillIndirect Cooking Food SafetyDirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Routine Care Why Clean?General Cleaning Storing Your GrillUSE and Care LP Liquefied Petroleum GasLP Cylinder Filling LP Cylinder Leak Test For your safetyDo not use household cleaning agents. Damage to gas Nipple has to be centered into the LP cylinder valveLeak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckTurn gas OFF at control knobs and LP cylinder Cleaning the Burner AssemblyStoring Your Grill Very Important Burner tubes must reengage valveLimited Warranty Disclaimer of Implied Warranties and Limitation of RemediesParts List Key Qty DescriptionNot Pictured Parts Diagram Assembly Upper Front panelQty Tank Retainer ,Wire Form Hitch Pin Qty #10-24x1/2 Machine ScrewQty 20x1/2 Machine Screw Page Sideburner Valve Ten t Page Hose Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Page Warranty Registration Department Box Columbus, GA