Char-Broil 463247512 manual AA battery Cap, Wire

Page 21

16 Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel with the nut, shown A.

Insert AA battery into ignition module, negative (–) end first. Then put on the cap, shown B.

Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the electronic ignition module. Total (5) connections. Connect the two wires (A and B) from the switch wiring harness into the back of the electronic ignition module. Total (2) connections, shown C.


				B
			-			+
			-
	A
	A					AA battery Cap
						AA battery Cap

Electronic
ignition module	Right side panel

C

Nut
NOTE: Switch terminals are larger than electrode	3	A	wire
			wire

terminals and should only be installed in	4		1
location shown as A, B.	5	B	2
		B

17

Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door.

Right door

PRESS

Top of door

Hinge pin on bottom of door

21

Image 21

Contents Date Purchased Product GuideThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling UL listed Overfill ProtectionFor your safety UseDo not household cleaning agents. Damage to gasLP Cylinder Leak Test Leak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjurySDo not lean over grill while lighting Open lid during lightingSideburner Ignitor Lighting General Grill CleaningSideburner Match Lighting Burner Flame CheckStoring Your Grill Cleaning the Burner AssemblyVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderItems Manufacturer will not PAY for Limited WarrantyKey Qty Description Parts ListParts Diagram Assembly Grill head Regulator hose Rear of Shelf Now you may fully tighten lower screws on upper back panel Front of ShelfBack of main control panel Holes on fascia to Attach valve bracketHoles on fascia to Attach bezel Sideburner lid Sideburner griddle Sideburner grate Front brace Wire AA battery CapFlame tamer Pin Slide into slots Important safety instructions before using Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionWarranty Registration Department Box Columbus, GA