Coleman 9993 Series Assemble the Doors and the Tool Hook, Assemble the Propane Tank Retainer

Grill Assembly (continued)

Assemble the Grill Lid (continued)

5.Install one washer and a hairpin cotter on each pin (Fig. 26).

Fig. 26

Assemble the Warming Rack and the Grease Tray

Fig. 27

Assemble the Wire Shelf

1. Insert the ends of the Wire	2. Use a screwdriver to loosen
Shelf into the holes provided in	the brackets (Fig. 32).
the left side	Place the wire under the
panel (Fig. 31).	two brackets and retighten
	the screws.
Fig. 31	Fig. 32

Assemble the Doors and the Tool Hook

Fig. 28 Fig. 29

1.Install both doors by first inserting the lower pin in the hinge hole (Fig. 33). Then depress the upper retractable pin and allow it to snap into the upper hinge hole. NOTE: if the doors need vertical alignment, place one or more washers (provided) on the lowest post.

2.Assemble the Tool Hook to the left door using three screws. Tighten the screws with a screwdriver (Fig. 34).

Assemble the Propane Tank Retainer

1.Insert the ends of the Propane Tank Retainer into the holes provided in the right side panel (Fig. 30).

Fig. 30

Fig. 33 Fig. 34

10