20# LP Cylinder Installation

Grill Assembly (continued)

Assemble the Side Tables

1. Align the tabs on the Side			2. Use firm pressure to push the
Tables with the slots on the			Side Tables down and into
side of the grill (Fig. 35).			place (Fig. 36). The joint
			between the Side Tables
			and the Grill will be even.

Fig. 35			Fig. 36

3.Engage the locks by firmly pushing the tabs into the slots (Fig. 37). Be sure to engage two locks on each side table.

Fig. 37

NOTE: Your 9993 Series grill is set up from the factory to use a 20# refillable LP cylinder. You may purchase a 20# LP cylinder from the store where you bought your grill, or from your local propane dealer.

WARNING

This procedure MUST be performed OUTDOORS only! Be sure the L.P. cylinder valve is closed. Attach to the grill. Read and follow the directions on the cylinder.

20# LP Cylinder Installation (continued)

1.Set the LP Cylinder in the Cylinder Support location with the outlet valve facing toward the door opening of the grill. Lower the Tank Support to engage the Cylinder Collar (Fig. 38).

Fig. 38

WARNING: During assembly of the grill and when attaching or replacing the L.P. gas cylinder, insure that the gas supply hose is free of kinks and/or damage and is at least 3 inches away from hot surfaces such as the grill casting.

CAUTION

In the connection process, the grill side of the connection will seal on the back-check in the valve, resulting in a slight resistance. The connection requires about one-half to three- quarters additional turn to complete the connection.

To disconnect, turn counterclockwise. Tighten by hand only. DO NOT use tools.

IMPORTANT!

TO ENSURE PROPER GAS FLOW, BURNER

CONTROL VALVES MUST BE “OFF” BEFORE OPENING

THE GAS CYLINDER VALVE.

3. Check that the cylinder valve	Fig. 39
is closed by turning the
cylinder knob clockwise to a
full stop (Fig. 39).