Coleman 8350 Series, 9992-648 manual Steps For Replacing the Electrode Module

Care, Maintenance and Cleaning (continued)

Replacing the Electrode Module

Steps For Replacing the Electrode Module:

1.Remove the cooking grates and the heat tents and set aside.

2.Using a 1/4” hex nut driver, remove the self-tapping screws holding the front heat shield (Fig. 33 and 34). Set the front heat shield aside.

3.The electrode module is now visible. Remove the three wires that are factory installed from the electrode module to the burner electrodes (Fig. 35).

4.To remove the electrode module, unscrew the igniter button and remove the AA battery. Next, unscrew the plastic hex nut from the electrode module (Fig. 36).

5.Reverse the procedure to install a new electrode module.

NOTE: It does not matter which ignition wire goes to which tab on the electrode module.

Fig. 33

Fig. 34

Fig. 35

Electrode
Module	Wires

Fig. 36

23