14.Position left side shelf over shelf mounting brackets
15.To begin installation be sure to align large shelf (holes) with the small holes in
the shelf bracket assembly. Insert (2) #10 x 1/2" Truss head screws (phillips drive) into largest hole on outside rear corner of shelf carefully aligning with small hole in shelf mounting bracket. Repeat procedure for inside rear.
Outside hole | Inside hole |
|
Rear View
16.To install shelf trim, tilt grill onto opposite shelf supports, align large holes in shelf bracket and shelf witht the small holes in the shelf trim. Then
place (2) #10 x 1/2" truss head screws into larger holes first (underneath shelf) and tighten securely.
Front View
/
/
17.After securing shelf trim to shelf/shelf bracket, align large hole on inside flange with large hole in control console and small hole in casting support bracket and insert (1) #10 x 1/2" truss head screw.
\ |
|
| & |
| \ |
|
|
|
| \ |
|
|
|
| #10 x 1F2Phillips Screw |
13