Kenmore 16238 manual Securely.Do not overtighten

Page 21

30.InstallLid,Overlay,Handle,CookingGrid,WarmingRack,HingeClip,andLogo.

Installlidbeforeinstallingoverlay,logo,andtemperaturegauge.

1.Installlidandhingeclipasshown.

2.Placeoverlayontopoflid

3.Attachlogo

NOTE: Tighten wing nuts

securely.(Do not overtighten)

5.Install temperature gauge.

6.Place handle ends into handle tube as shown

Note: Notches in handle tube mate with tab inside handle cap as shown

End

_andle

Handle

Tube

4. Secure overlay with

(2) # 6 wingnuts.

..... ®

Warming

Note: Keep handle tube aligned with end caps at all times.

Cooking Grids

7. Then place handle assembly onto lid and secure with washers and #10 wingnuts.

8. Install cooking grids and warming rack as shown.

#10-24Wing Nut #10 Washer 3/8"-16Knurl Nut #6-32Wing Nut

21

Image 21

Contents This Grill is for Outdoor USE only Specific Grill Parts If YOU Smell GASCarbon Monoxide Hazard Call Grill Service Center For Help And PartsCaring for Your Equipment Getting Familiar with Your GrillGAS Cylinder NEW OPDFilling Stops AT 80% LP Tank Valve Hose & RegulatorCylinder CAP StrapLighter/Burner Bagpack Master BagpackFIG. a Wingnut 20 X 1/2 Carriage Bolt Page 800-488-1 That they are not against any sharp surfaces #10 x 1/2Phillips Screw Outside hole Inside hole FIG B Eyelet Green Ground WireBurner Tube Orifice #8 x 3/8 Tapping Screws Knob Front View Page Burner Tube Orifice Tabs in cross lighter top fit Into grooves on top of burners Rib in Base Casting Securely.Do not overtighten Oll I0nitorModule Page LOW HighBreaking in Your Grill Cooking TemperaturesCooking Techniques Grill Cooking MethodsCleaning Venturi Tubes Perform a Leak TestLillll Cooking System Cleaning Other Parts of Your ApplianceGrill INTERIOR, Warming Rack Grease TrayREF # QTY Description KenmorePropaneGasGrill4Jlie J 1JlvA I W Burners will not light LE-FOYER Mc