Kenmore 141.16322, 141.16324 manual Install Side Burner Kit

Page 15

Install Side Burner Kit

[] Insert the Side burner Gas Valve Assembly into Side Burner Tube (See Figure 1). Be sure the orifice is inside the Burner Tube properly (see warning on Page 3), or lighting the burner may

cause explosion and/or fire.

[] Insert the Side Burner Gas Valve Assembly through the Side Burner Gas Valve Hole on the Side Burner Frame. Align the 2 holes on the Side Burner Frame with the threaded holes on the Side Burner Gas Valve Bracket. Then insert the two (2) screws and washers provided and tighten securely.

[] Fasten the Control Knob onto the Side Burner

Gas Valve Stem. Be sure that the OFF position faces the Burner.

[] Connect the Electric Wire terminal from Side Burner with the other from Grill Head as shown.

Bind the connected Electric Wire and Side

Burner Connection Tube together using the

supplied Fastening Band.(Note: located in Operator's Manual plastic bag).

[] The gap between the Side Burner Electrode Tip

and the Side Burner Port should be

approximately 1/8"~ 3/16". If the gap is wider than 3/16", use a pair of long nose pliers and gently bend the Electrode Tip toward the burner.

[] Cut and remove Fastening Band from Side

Burner and Pot Support before use.

Side Burner Pot Support

[] Place the Side Burner Pot Support into the Side Burner Frame.

[] Place the Side Burner Wind Shield on the Side Burner Frame.

Pattern Head Screw M4x8mm

Qty. 2

Part # $132M04082

©

Plain

Washer M4

Qty.

2

Part

# S411M04122

Control Knob for Side Burner

Qty. 1

Part # P03426083H

Scale 1:2

Figure

Electrical connection

1/8.~3/16.BURNER PORT

Fastening Band

Qty. 1

15

Image 15
Contents Operatorsmanual One-Year Full Warranty on Kenmore Grill Additional Limited Warranty on Specific Grill PartsGrill Installation Codes Grill information Center Failure to comply with these instructions couldRedu Part Description QTY Purpose of Part Page 2436 Page 16324 16322 KEY PIN QTY Description16322 16324 KEY Description PIN QTYInstall Cart Bottom Shelf Install Cart LegsInstall Casters and Wheels Install Cart Rear Panel For Model 141.16324 onlyInstall Door Bracket, Magnetic Door Stops Door Stop Plate Install Cart Side PanelsInstall Door Handles and Door Bolts Install Doors to CartInstall Left Side Shelf and Side Burner Frame Install Lighting Stick and Grease Draining TrayInstall Side Burner Kit Install Ignitor Battery Install Cooking ComponentsSide Burner Electrode Check Correct LP GAS Tank USE How to Leak Test your LP Gas Tank For you r safetyCheck all connections for LP Gas Leaks Disconnecting a Liquid Propane Gas LPG Tank From Your GrillManually Lighting Your Grill By Paper Match Side Burner Lighting InstructionsGrill Lighting Instructions Correction Troubleshooting If the grill fails to lightCleaning The Grease Tray and Receptacle Annual Cleaning of The Grill InteriorCleaning Exterior Surfaces Extended Burn-Off PreheatingUse your grill at least 3 feet away from any Page Answer Question My grill will not light properly. Why?Question MY-HOME