Checking for LP gas leaks
Never test for leaks with a flame. Prior to first use, at the beginning of each season, or every time your LP gas tank is changed, you must check for gas leaks.
,Make a 50/50 (soap/water) mild soap solution.
2. Turn the control knobs to full OFF position; then turn gas ON at supply tank.
,Apply the soap solution with a clean brush to all gas connections. See below. If growing bubbles appear in the solution the connections are not properly sealed. Check each fitting and tighten or repair as necessary.
Gas Connection Leak Check
4.If you have a gas connection leak you cannot repair, turn gas OFF at supply tank, disconnect fuel line from your grill and call
5.Also apply soapy solution to the tank seams. See below. If growing bubbles appear, shut tank OFF and do not use or move it! Contact an LP gas supplier or your fire department for assistance.
Gas Tank Leak Check
,Be sure all gas connections are securely tightened.
4.Open the Gas Grill Lid.
5.Push and turn any main burner knob to _ HI position. Push Electronic ignition button for 3 to 5 seconds to light burner. Adjust knob to desired setting.
,If the burner does not light after 5 seconds, turn knob to OFF. Turn gas OFF at LP tank and wait 5 minutes for gas to clear. Then turn gas ON at tank and repeat step 5
,If burner still does not light, see Match Lighting section and If Grill Still Fails to Light section on following page.
,To light additional burners, turn burner knob(s) to _ HI. Push electronic ignition button for 3 to 5 seconds to light burner. Adjust knob(s) to desired setting.
Grill Lighting Instructions for Main Burners
1.Do not smoke while lighting grill or checking gas supply connections.
2.Be sure that LP gas tank is sufficiently full.
//_k WARNING
Failure to open grill lid during the lighting procedure could result in a fire or explosion that could cause serious bodily injury, death, or property damage.
16