Electrolux 65852 G manual Fitting the Hob into the Worktop

Page 20

20

Fitting the Hob into the Worktop

Carry out the building in of the hob as follows:

1.place the seals supplied with the hob on the front edge of the cut out. Then, place them at 11 mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking care that the seals meet without overlapping.

2.Place the hob in the cut out, taking care that it is centred.

3.Fix the hob with the relevant fixing clamps, supplied with the injectors kit (see diagram). When the screws have been tightened, the excess seal can be removed.

The edge of the hob forms a double seal which prevents the ingress of liquids.

Seal

Image 20
Contents 65852 G Welcome to the world of Electrolux Contents Important Safety Information InstallationChild Safety During UseAny new owner Service∀ Environmental Information Installation Description of the HobsLighting the burners OperationHob burners control knobs Using the hob correctly Burner Minimum Maximum DiameterUsing the Wok Stand Quale bruciatore suggerisre per la gri- glia WOK qui?Pan Supports Maintenance and CleaningHob Top Burners Ignition electrodeSymptom Solution Something Not Working?Instructions for the Installer Engineer technical dataAeration adjustment none Important safety requirements LocationInstallation Gas Connection Building over a cupboard or drawer Cut Out SizeBuilding Building over a kitchen unit with door Fitting the Hob into the Worktop Electrical connections This HOB Must be EarthedWiring diagram Permanent ConnectionFault Finding Preliminary Electrical Systems CheckEarth Continuity Check Ignition System / Gas Ignition Ignitor does not sparkCommissioning Pressure TestingMinimum adjustment screw Conversion from Natural Gas to LPG MethodExclusions Guarantee/Customer ServiceStandard guarantee conditions 0870 5 929 Service and Spare PartsCustomer Care European Guarantee