19
Lighting the Grill Using the Pulse-Spark Ignitor
!WARNING
To reduce the risk of death or serious injury from an explosion or a fire beneath the grill:
•Inspect and clean Burner/Venturi Tubes for insects or insect nests. Spiders or small insects can build nests, webs, and lay eggs in the grill’s Venturi Tubes, (Fig 15, page 28) obstructing the flow of gas to the Burner. The
•Be sure Burners are
Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the “How to Clean your Burners” section on page 28, to remove any possible obstructions.
!WARNING
To reduce the risk of serious bodily injury or death from fire or explosion:
•Open Hood before lighting the grill to prevent an explosion from gas
•During failed lighting attempts, or if the Burners go out during operation, turn Control Knobs “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.
•Light each burner from the left before lighting the next burning to prevent gas from accumulating.
1.Open the Hood.
2.IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 7)
3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)
Control Knob in | Control Knob in High |
|
position (large flame |
| |
Off position | symbol) | Turn LP Gas |
|
| |
|
| Cylinder valve |
| Fig. 8 | counterclockwise |
Fig. 7 |
|
|
Left Main Burner
Control Knob
Fig. 9 | Igniter Button |
|
Right Main Burner Control Knob
4.Push far left Main Burner Control Knob in on Control Panel and turn counterclockwise to the High position. (Figs. 7 and 9)