7.TOP GRATES:
Place a grate over each of the radiants. For normal operation, the pointed side of the grate is facing up. For use with foods that require extra support, the flat side may be used.
On XX Models, grates can be placed on three levels; two positions are built into the rear of the unit; the third position requires a special adapter. On CH models, three positions are already built into the rear of the unit.
8.LIGHTING:
Each burner on the base char broiler has a standing pilot burner that must be lit before the burners can be lit. To light the pilot burners:
(a)Turn all broiler valves to the off position.
(b)Remove each top grate and radiant.
(c)Open main gas
(d)Allow air to bleed from the gas line through the pilot burners.
(e)Light the pilot burners using a lit taper.
(f)Turn the burner control valves “ON” to light the burners.
(g)If any burner fails to light, turn the burner valves to “OFF”, wait five minutes and repeat the above procedure.
(h)After all burners have been ignited properly, turn each burner valve “OFF” and allow the unit to cool. NOTE: Make sure that the pilot burners stay lit.
(i)Replace radiants and top grates.
(j)Each burner may now be adjusted to the desired flame size by turning the individual burner valve handle.
(k)To shut down the unit, turn all valves “OFF”
Wait five minutes before attempting to
NOTE: The pilot burners will stay lit until the gas supply to the unit is turned “OFF”.
9.GRIDDLE PLATE:
Griddle plates should not cover more than 50% of the BROILING area. Each Griddle Plate fits on top of two grates (one 4 1/2” and one 6”). It is not necessary to remove the top grates and radiants before installing the griddle plate.
10.ADDITIONAL INSTALLATION INSTRUCTIONS
(a)Keep the area around the broiler free and clear of combustible materials.
(b)The provision of an adequate air supply to your broiler is essential. Provide for sufficient outside air to enter the broiling area and assure that this airflow is not obstructed.
(c)Air enters the burner area from the front and bottom of your broiler. Assure that these areas are kept open and unobstructed.
(d)Servicing is accomplished through the front and top of the broiler. Assure that these areas are kept unobstructed for proper servicing and operation.
11.INSTALLATION WITH CASTERS
(a)Install the casters with the wheel brakes on the front of the appliance.
(b)Installation should be made with a connector that complies with the latest edition of the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 in the USA
(c)The restraint should be attached to the legs on which the casters are mounted.
(d)If disconnection of the restraint is necessary, the restraint should be reconnected after the appliance has been returned to its originally installed position.
6