Bakers Pride Oven XX, CG operating instructions Broiling Procedure, Helpful Hints

Page 7

II.OPERATING INSTRUCTIONS

1.LIGHTING PROCEDURE:

See section 8 of INSTALLATION INSTRUCTIONS. Once the pilot burners are lit, the broiler may be turned “ON” or “OFF” by turning the control valves on or off as necessary.

2.BROILING PROCEDURE:

BROILER TOP GRATES MUST BE HOT ENOUGH TO MAKE BLACK CHAR-MARKS WHEN STARTING TO BROIL.

Adequate pre-heating time is necessary for the food to release from the broiler and to cook properly. Allow the unit to pre-heat for 45 minutes to 1 hour before broiling.

(a)SEASONING:

Marinades with oil and vinegar or wine bases are best applied at least 1 to 2 hours before broiling. Spice mixes, such as flavored salt etc., should be applied 10 to 30 minutes before broiling. Tomato and sugar based products, such as barbecue sauces etc., have a tendency to burn and should be used prior to removing the food from the broiler, or after removal.

(b)STEAK AND CHOPS:

Cuts of meat with bones require longer cooking times at lower temperatures to reach the same internal doneness as cuts without bones. To prepare a well-done steak, trim the fat to reduce flare-up and the tendency to burn the outside.

(c)HAMBURGERS:

Chopped steak, etc. MUST NOT BE TOO LEAN. For fat flare and smoking action in char-broiling, hamburgers should have about 25% fat content.

Fat rendered out during broiling:

(1)Helps to release the burger from the grates.

(2)Helps the searing action that seals meat juices inside.

(3)Enhances the char-broil flavor by flaring-up in the form of smoke and flame.

(d)THICKNESS:

During the broiling process, the hamburger contracts and becomes thicker and smaller in diameter. Pressing the hamburger out thin before broiling will compensate for the shrinkage. Broil a hamburger as you would broil a steak.

(1)Be sure that the char-broiler has had adequate pre-heating time so that the hamburger does not stick to the broiler grate.

(2)Place the hamburger on the grate and allow it to cook until release is attained.

(3)Once the hamburger releases from the grate, turn it over and allow it to cook for 1 minute, then turn once a minute until the desired degree of doneness is attained.

(e)COOKING TOOLS:

Bakers Pride has designed a number of tools to help you operate more efficiently including a special spatula that is very effective for fish and hamburgers. Other tools are available. Contact the factory for full details

3.HELPFUL HINTS:

(a)Do not press the juice out of the meat because that will cause a dry product.

(b)Allow the meat to sit covered on a heated platter for 2 to 5 minutes after broiling before cutting. This will allow the juices to “settle” and the product will be more moist.

(c)Do not use forks or other sharp objects which poke holes in the meat. Do not cut the meat as it cooks

(d)Thick pieces of meat require a longer broiling time with less flare-up. Reduce flare-up trimming excess fat for a longer broil time without burning.

(e)Keep the unit clean. Food caught between the grates will not allow hot air to rise around the product. This will result in uneven heating and increase cook time.

7

Image 7
Contents Important Instructions Dante SeriesImportant for Future Reference Section IndexGAS Connection InstallationGeneral Acceptable ClearancesRadiants BurnersLighting Additional Installation InstructionsInstallation with Casters TOP GratesHelpful Hints Broiling ProcedureService MaintenanceONE Burner Fails to Light Burner Flame AdjustmentPilot Flame Adjustment Lack of HeatValve Assembly Views XX-4, 6, 8, 10 Exterior / Grates XX-4, 6, 8, 10 CH-6, 8, 10, 12 T1252T Griddle Plate 18 In Line Bakers Pride Limited Warranty