Aussie 6703T8DV31 manual How to Perform a Leak Test First Time USE and as required

Page 16

16

How to Perform A Leak Test “FIRST TIME USE” and as required

Supplies Needed for a Leak Test:

Clean paint brush

Water

Dish washing liquid

1.Use an LP Gas Cylinder equipped with an OPD (Overfill Prevention Device) and have it filled at an authorized LP gas dealer by a qualified attendant.

2.Make sure all grill Control Panel Knobs are turned to the “Off” position and verify that the LP Gas Cylinder valve is closed by turning the knob on the LP Gas Cylinder clockwise until it stops.

3.Mix one part of water with one part of dish washing liquid.

4.Figures 1, 2, 4 and 4a show the grill at assembly step 7, prior to attaching the Side Tables, and illustrate the initial steps in the “FIRST TIME USE LEAK TEST”.

Detach the Control Panel from the Grill Body/Firebox by removing the two 5/32” Bolts from each end. (Fig. 1) Gently pull the Control Panel away from the Body until Valves disengage from the Tubular burner ends. (Fig. 2) Support the Control Panel to keep tension off of the igniter wire leads or detach the wire leads from the Starter Button module.

Tubular Burner

Ends

Fig. 1

Fig. 2

5. With the regulator hose connected to the LP Gas Cylinder, turn the knob on the Cylinder counterclockwise. (Fig. 3).

 

Fig. 3

 

Check for leaks at

Coupling

Cylinder Valve and

Regulator Connection

Nut

and Fittings

 

Fig. 4

!CAUTION

To reduce the risk of a laceration hazard:

• Wear protective gloves when removing or replacing Control panel, which could have sharp edges.

Image 16
Contents DA N G E R Tools Required for Assembly Supplied with Grill Carbon Monoxide HazardPacking List DescriptionContents Preparation for AssemblyStep Left Leg Frame Assembly Assembly InstructionsStep Right Leg Frame Assembly Step Cart Frame Assembly Step Wheel AssemblyStep Steel Privacy Panel Assembly Step Cylinder Blocking Wire AssemblyStep Hood/Body To Cart Assembly Step Side Table Assembly Step Side Burner Valve Assembly Step Side Burner Igniter Wire ConnectionStep Side Burner Control Knob Assembly Side Burner Grid AssemblyStep Bottom Body Panel Assembly Foil Pan/Grease Pan AssemblyStep Warming Rack / Flavor Activator / Cooking Grid Assembly Step Battery in Igniter InstallationUsing Gas Connecting/Disconnecting the GasLP Gas Cylinder Disconnecting LP Gas Cylinder Connecting LP Gas CylinderLP Hose and Regulator Before Using Your LP Gas Grill Installation CodesSelecting a Location Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Page Lighting the Grill Using the Pulse-Spark Ignitor Off positionManual Lighting of the Grill on Manually Lighting the Grill Check The Flame Lighting the Side BurnerManually Lighting the Side Burner Manually Lighting the Side Burner Cooking On the Gas Grill Grill Cooking Direct MethodDirect Cooking on the Grids Roasting Indirect MethodIndirect Cooking Roasting Warming Rack End of Cooking SessionCare and Maintenance Cleaning the GrillHow to Clean the Burners Open up Storage Troubleshooting EmergenciesMaintenance Clean the Burners. See How to Clean Burners in CareSee How to Clean Burners in Care and Maintenance Important Notice Page Parts Illustration Parts List Key Description QuantityLimited Warranty Meco Corporation Limited Warranty