32
Problem
Flare up
Persistent grease fire
Unable to fill LP tank
Humming or whistling from regulator
Possible Cause
Grease
Excessive fat in meat
Grease trapped around burner system
Some dealers have older fill nozzles with worn threads
Outside temperature, humid- ity, barometric pressure, and the gas level within the tank may cause the rubber dia- phragm inside the regulator to vibrate, making a humming or whistling sound.
Solution
Clean grill.
Trim fat from meat before grilling.
Turn Control Knobs “Off” and turn handle of LP Gas Cylinder clockwise until it stops. Open Hood carefully and let fire burn out. After the grill cools, remove and clean all parts.
The worn nozzles do not have enough “bite” to engage the valve. Try another licensed LP dealer.
Although this sound may be alarming, this is NOT danger- ous as long as it is not accompanied by the smell of gas. Simply adjust the Burner settings, and usually the sound will subside. If the humming sound persists, a change in atmospheric conditions will eventually stop the vibration.
Cabinet doors do not close Doors magnets loose. | Tighten Door Magnet bolts and nuts. |
Doors not aligned. | 1. Loosen bolts and bottom door brackets. Align doors |
| 2. Loosen bottom side panel bolts inside cabinet. Apply |
| pressure to one side until doors are aligned. Retighten |
| bolts. |
If your problem is not resolved from the information provided above,
please call Customer Service at
of purchase will be necessary.
IMPORTANT NOTICE
The Gas Grill is set up to operate with a LP Gas Cylinder equipped with an OPD (Overfill Prevention Device).
This is a secondary device to prevent overfilling your LP Gas Cylinder. The proper methods for the filling of your LP Gas Cylinder are by weight or volume, as described in NFPA 58. Please make sure your filling station fills your LP Gas Cylinder by weight or volume. Ask your filling station to read purging and filling instructions on the LP Gas Cylinder before attempting to fill.
Rises up while filling, then stops when full.
!WARNING
Do not exchange the LP Gas Cylinder unless the exchange LP Gas Cylinder is equipped with an OPD. Otherwise you will lose the OPD (Overfill Prevention Device) feature. If there is not an LP Gas Cylinder available for exchange equipped with an OPD, we recommend that you have your LP Gas Cylinder filled at an authorized LP gas dealer by a qualified attendant.