Broilmaster P3SX-1, H4XN-1, H4PK-1 SERIES Installing the Burner, Series Burner Shown, Series Shown

6.The burner bracket should be at a slight angle as shown in Figure 12. Once the proper angle is achieved, tighten the screw securing the burner bracket to the venturi assembly and burner body.

Installing the Burner

1.Insert the burner assembly into the grill bottom with the venturi tubes facing the front of the grill. See Figure 14.

11°

C

L

“H” Series Burner Shown

Figure 12

7.Insert the 1/4-20 x 1 1/2 Phillips Truss Head Screw from the underside of the grill and secure with the 1/4-20 Hex Nut. See

Figure 13.

Figure 13

Figure 14

Note: If the Grill Head is installed on a PCB1 or DCB1, make sure the cart shield is not installed until the burner bracket is mounted.

2.Slide the venturi on to the valve assembly.

3.Raise the unsecured end of the burner bracket and slip it over the 1/4-20 x 1 1/2 Phillips Truss Head Screw as shown in Figure

15. The screw will fit into the hole on the burner bracket.

“P” Series Shown

Figure 15

B101623-5-1012 Page 27