Broilmaster SSPB26-1 owner manual Patio Base Assembly

Page 6

PATIO BASE ASSEMBLY

The BPB26 and SSPB26 Patio Base are only for use with Broilmaster Gas Grills. Before proceeding with installation read the Owner’s Manual for the proper loca- tion and minimum clearances to combustible materials for your grill and patio base.

Verify that all parts listed in the exploded view of this product have been included before beginning this in- stallation.

Recommended Tools:

Two adjustable wrenches or a socket set

A medium Phillips screwdriver

Pipe thread sealer or Teflon tape (for gas connec- tions)

Soapy water solution (to test for leaks)

2

Fasten the bottom of the post to the cast iron patio base (9) using 9/32 ID x 5/8 OD flat washers, 1/4 lock washers, and 1/4-20 hex nuts. FIGURE 2.

Anchor the cast iron patio base to your patio using the two holes provided in the base. (Hardware not included)

Note: Make sure that the large rectangular cut out is facing in the direction that you want your grill to face.

FIGURE 2.

1

Attach four 1/4-20 x 4" eyebolts (8) to the bottom of the 26" square post (7) using 1/4 - 20 x 3/4" bolts (5), 9/32 ID x 5/8 OD flat washers (1), 1/4 lock washers (2), and 1/4-20 hex nuts (3). Figure 1.

NOTE: The large rectangular cut out is located at the front of the post near the top.

Figure 2

3

Insert the stainless steel flex tube assembly into the post.

The inlet side of the gas tubing may protrude from the bottom of the patio base or through the large circular hole in the back of the square post.

Note: Do not attempt to cut or alter the flex tube in any way.

Figure 1

Page 6

B101075-1-0807

Image 6
Contents BPB26-1 and SSPB26-1 Patio Base This GAS Accessory is Designed for Outdoor USE only Table of Contents Grill Location Important InformationPatio Base Parts List & Exploded View BPB26 SSPB26Patio Base Assembly LP GAS Broilmaster