2Wire AVX-7300 Operation of the Display, Deploying the Display, Turn your vehicle’s engine on

Page 12

Operation of the Display

Operation of the Display

Deploying the Display

Turn your vehicle’s engine ON.

The display will be automatically deployed by the automatic close/open mode.

If the display is not automatically deployed, press the OPEN/CLOSE button.

Note:

The automatic close/open mode will operate the display as follows.

*When the ignition switch is turned OFF while the display is deployed, the display will be closed after approximately 6 seconds.

When the ignition switch is turned ON again (or turned to ACC), the display will be deployed automatically.

*When using an AUDIO VISUAL MASTER UNIT, turning the power of either of these on will deploy the display automatically.

*Installing the front panel will automatically deploy the display. (Refer to page 5.)

The automatic close/open mode can be switched ON/OFF. (Refer to page 14.)

When the ignition switch is turned OFF after the display has been closed, turning the ignition switch ON again (or turning it to ACC) will not deploy the display. In this case, press the OPEN/CLOSE button to deploy the display.

7

Image 12
Contents AVX-7300 Level Example To establish a safe levelPrecaution For U.S. and Canadian ModelsAbout This Product 7U.S.AImportant Safeguards Before Using Contents Before Using Before Using This ProductHow to Use This Manual Before UsingBe Sure to Adjust Picture Brightness To Ensure Safe DrivingPreventing the Battery from Becoming Exhausted Resetting the MicroprocessorResetting Case of TroubleDetaching and Replacing the Front Panel Theft ProtectionDetaching the Front Panel Replacing the Front PanelKey Finder Operation of the Display Deploying the DisplayOperation of the Display Turn your vehicle’s engine onScreen Angle Adjustment Adjust the screen to an easily viewable angleClosing the Display Turn the vehicle’s engine OFFChanging the Wide Mode Switching the Illumination Color For European models Switch to the desired illumination colorSwitching the Video Source Switching to RGBSwitch to RGB Switching to AV and VTRSetting the Display Operating the Setting MenuEntering the Display Setting Menu Setting the DisplaySwitching the Video Select Setting Setting the Automatic Open ModeOpen in the Display Setting Menu Switch the automatic open ON/OFFAdjusting the Bright Adjusting the ColorAdjusting the Hue Adjusting the DimmerAdjust the Hue Press the Wide button and select the Dimmer mode DimmerUsing the Display Correctly OthersHandling the Display OthersAbout the Liquid Crystal Display LCD Screen Keeping the Display in Good ConditionAbout the Small Fluorescent Tube Specifications AppendixAppendix General DisplayAppendix Page Page Pioneer Corporation