2Wire AVX-7300 operation manual Closing the Display, Turn the vehicle’s engine OFF

Page 14

Operation of the Display

Closing the Display

Turn the vehicle’s engine OFF.

The display will be automatically closed by the automatic close/open mode. If the display does not close automatically, press the OPEN/CLOSE button.

Note:

When closing the display, check to make sure that it has closed completely. If the display has stopped halfway, leaving it like this could result in damage to it.

The automatic close/open mode will operate the display as follows.

*When the ignition switch is turned OFF while the display is deployed, the display will be closed after approximately 6 seconds.

When the ignition switch is turned ON again (or turned to ACC), the display will be deployed automatically.

*Removing the front panel will close the display. (Refer to page 5.)

The automatic close/open mode can be switched ON/OFF. (Refer to page 14.)

When the ignition switch is turned OFF after the display has been closed, turning the ignition switch ON again (or turning it to ACC) will not deploy the display. In this case, press the OPEN/CLOSE button to deploy the display.

9

Image 14
Contents AVX-7300 Level Example To establish a safe levelAbout This Product PrecautionFor U.S. and Canadian Models 7U.S.AImportant Safeguards Before Using Contents How to Use This Manual Before UsingBefore Using This Product Before UsingBe Sure to Adjust Picture Brightness To Ensure Safe DrivingResetting Preventing the Battery from Becoming ExhaustedResetting the Microprocessor Case of TroubleDetaching the Front Panel Detaching and Replacing the Front PanelTheft Protection Replacing the Front PanelKey Finder Operation of the Display Operation of the DisplayDeploying the Display Turn your vehicle’s engine onScreen Angle Adjustment Adjust the screen to an easily viewable angleClosing the Display Turn the vehicle’s engine OFFChanging the Wide Mode Switching the Illumination Color For European models Switch to the desired illumination colorSwitch to RGB Switching the Video SourceSwitching to RGB Switching to AV and VTREntering the Display Setting Menu Setting the DisplayOperating the Setting Menu Setting the DisplayOpen in the Display Setting Menu Switching the Video Select SettingSetting the Automatic Open Mode Switch the automatic open ON/OFFAdjusting the Bright Adjusting the ColorAdjust the Hue Adjusting the HueAdjusting the Dimmer Press the Wide button and select the Dimmer mode DimmerHandling the Display Using the Display CorrectlyOthers OthersAbout the Small Fluorescent Tube About the Liquid Crystal Display LCD ScreenKeeping the Display in Good Condition Appendix SpecificationsAppendix General DisplayAppendix Page Page Pioneer Corporation