SAFETY INSTRUCTIONS FOR INSTALLATION
Note to the installer:
Please leave this instruction book with the consumer for the local electrical inspector’s use.
The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire.
The cabinetry and venting hood should be installed first to prevent damage to the appliance.
~The countertop must be bonded with heat resistant (212 °F/100 °C) adhesive to prevent distortion or dissolving.
The wall strips must be
~To eliminate the risk of burns or fire by reaching over heated surfaces cabinet storage space above the appliance should be avoided. If cabinet storage is necessary, the risk can be reduced by installing a venting hood to project horizontally a minimum of 5"
(127 mm) beyond the bottom of the cabinets.
~This appliance has not been designed for maritime use or for use in mobile installations such as recreational vehicles or aircraft. However, under certain conditions it may be possible for installation in these applications. Please contact the Miele Technical Service Department with specific requirements.
~The grill must not be installed directly next to the CS 1421
(Salamander). It is essential to maintain a distance of at least 5 7/8" (150 mm) between these two appliances.
~You must ensure the power cable for the appliance will not come under any mechanical strain once installed e.g., while the water is draining.
~Be sure that after installation the power cord does not come into contact with any parts of the appliance which may become hot.
~The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. See "Sealing".
Keep this instruction book in a safe place for reference and pass it on to any future user.
20