Char-Broil 463741209 manual Control panel

Page 20

7

(A)Attach control panel to cart with #10-24x1-3/4" machine screws and #10-24 wing nuts.

(B)Place valve/hose/regulator onto control panel. Attach with two #10-24x1/2" machine screws. (Note: Make sure the two valve stems are leveled; otherwise, this can cause main burner level problems.) Insert ignitor into control panel. Insert the round terminal plug of the ignitor wire into the pin located at the end of the ignitor.

Control panel

A

#10-24x1-3/4" Machine Screw Qty. 2

#10-24
Wing Nut
Qty. 2	Ignitor

B

#10-24X1/2"

Machine Screw

Qty. 2

Valve/Hose/Regulator

20

Image 20

Contents Product Guide INSTALLER/ASSEMBLER Installation Safety Precautions California PropositionTemperature First Time UseLava Rock / Briquettes Pre-Heating Your GrillFood Safety Direct CookingIndirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Why Clean? General CleaningRoutine Care Storing Your GrillLP Liquefied Petroleum Gas LP Cylinder FillingUL listed Overfill Protection Only LP cylinders equipped with this type of valveConnecting Regulator To The LP Tank For your safetyUseDo not household cleaning agents. Damage to gas LP Tank ExchangeTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator Safety Tips For Safe Use Of Your Grill And To Avoid Serious InjuryIgnitor Lighting SDo not lean over grill while lightingBurner Flame Check Hose CheckTurning Grill Off Ignitor CheckCleaning the Burner Assembly Turn gas off at control knobs and LP cylinderLimited Warranty Statement REV Page Parts Diagram Assembly Right leg Place rail with rating Label to back Support Bar Secure with #10-24x1/2 screws and #10-24 wing nuts Control panel Attach side shelves with #10-24x1-3/4 machine screws Center flat portion Hinge on bottom Hitch pins Swing Away Leg Wire Tank Collar Troubleshooting Emergencies Possible Cause Prevention/SolutionElectronic Ignition Page Page Page