Weber Spirit 500 series owner manual Add fuel scale assembly, Install igniter

Page 14

Step 10

Add fuel scale assembly

You will need: fuel scale assembly, two 1/4-20 wing nuts and two nylon washers.

Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame.

Add washers then wing nuts and tighten. Figure 12.

	E
	E
	F
	F
View from front left	View from front right

Figure 12

Step 11

Install igniter

Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.

The igniter lock nut is on the igniter.

Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 13 (b).Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure 13 (c). Tighten the igniter lock nut. Figure 13.

Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.

(a)

Frame brace

(b)

	Figure 13	Keyhole in	Igniter lock nut
		frame brace	Igniter lock nut
		frame brace
			(c)

Frame brace

Small part of keyhole in frame brace

14

Image 14

Contents Spirit 500 Series MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents Storage For Installation in CanadaGeneral Instructions Operating areaStep AssemblyCheck package contents Fuel scale assembly Five Flavorizer Bars Check contents of hardware packs Assemble wheel frame Assemble top frameAdd front panel Continue frame assemblyInstall tubing plugs Add cooking box Install manifold bracket Install tank panel assembly and frame connectorAdd fuel scale assembly Install igniterFill LP tank MCAUTION Do not remove adjustment wing nut from tank scaleSet LP fuel scale Check that all burner valves are off Connect LP tankMWARNING Do not ignite burners when leak checking Check for gas leaksAllowing grease to flow into the catch pan Install Flavorizer Bars and Cooking GratesInstall the bottom tray Install Lid Add tool holders, control panel and burner control knobsComplete accessory installation Lighting To ExtinguishManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRemoval of the LP tank Connecting the filled LP tankRefilling the LP tank Mix soap and water Open the tank valve. Figure Safe handling tips for LP Gas Liquid Propane LP TanksMWARNING Do not ignite burners while leak checking Annual MaintenanceInspection and Cleaning of the Weber Spider Stopper Guards MCAUTION Do not enlarge the burner ports when cleaning General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations When burner is on HIGH. Flames do not run Problem Check Cure Burners burn with a yellow or orangeBarbecue temperature only reaches 250˚ to Flame, in conjunction with the smell of gas11-12 Parts List Page Page Final Word Thanks