Weber Spirit 500 series Problem Check Cure Burners burn with a yellow or orange, High position

Page 31

TROUBLESHOOTING

Problem

Check

Cure

 

 

 

Burners burn with a yellow or orange

Inspect Weber Spider Stopper

Clean Weber Spider Stopper

flame, in conjunction with the smell of gas.

Guards for possible obstructions.

Guards. (See Section "Annual

 

(Blockage of holes.)

Maintenance".)

 

 

 

Burners do not light. -or-

The excess flow safety device,

To reset the excess flow safety

Burners have a small flickering flame in the

which is part of the barbecue to tank

device turn all burner control

HIGH position. -or-

connection, may have activated.

knobs and the tank valve OFF.

Barbecue temperature only reaches 250˚ to

 

Disconnect the regulator from the

300˚ degrees in the HIGH position.

 

tank. Turn burner control knobs

 

 

to HIGH. Wait at least 1 minute.

 

 

Turn burner control knobs OFF.

 

 

Reconnect the regulator to the

 

 

tank. Turn tank valve on slowly.

 

 

Refer to “Lighting Instructions”.

 

 

 

Burner does not light, or flame is low in

Is LP fuel low or empty?

Refill LP tank.

HIGH position.

 

 

Is fuel hose bent or kinked?

Straighten fuel hose.

 

 

 

 

 

Does the Front burner light with a

If you can light the Front burner

 

match?

with a match, then check the

 

 

Crossover Ignition System.

 

 

 

Experiencing flare-ups:

Are you preheating barbecue in the

All burners on high for 10 to 15

 

prescribed manner?

minutes for preheating.

 

 

 

 

Are the cooking grates and

Clean thoroughly. (See Section

 

Flavorizer Bars heavily coated with

"Periodic Cleaning".)

 

burned-on grease?

 

 

 

 

 

Is the bottom tray "dirty" and not

Clean bottom tray.

mCAUTION: Do not line the bottom tray

allowing grease to flow into catch

 

with aluminum foil.

pan?

 

 

 

 

Burner flame pattern is erratic. Flame is low

Are burners clean?

Clean burners. (See Section

when burner is on HIGH. Flames do not run

 

"General Maintenance".)

the whole length of the burner tube.

 

 

 

 

 

Inside of lid appears to be “peeling.” (Resembles paint peeling.)

The lid is porcelain-on-steel, not

Clean thoroughly. (See Section

paint. It cannot “peel.” What you are

"Periodic Cleaning".)

seeing is baked on grease that has

 

turned to carbon and is flaking off.

 

THIS IS NOT A DEFECT.

 

Fuel scale shows that there is gas in the LP Check adjustment of fuel scale. tank, but tank is empty.

Fuel scale must be adjusted with an empty tank.

If problems cannot be corrected by using these methods, please contact Weber-Stephen Customer Service.

31

Image 31
Contents Spirit 500 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageCheck package contents AssemblyStep Fuel scale assembly Five Flavorizer Bars Check contents of hardware packs Assemble top frame Assemble wheel frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install tank panel assembly and frame connector Install manifold bracketInstall igniter Add fuel scale assemblySet LP fuel scale MCAUTION Do not remove adjustment wing nut from tank scaleFill LP tank Connect LP tank Check that all burner valves are offCheck for gas leaks MWARNING Do not ignite burners when leak checkingInstall the bottom tray Install Flavorizer Bars and Cooking GratesAllowing grease to flow into the catch pan Add tool holders, control panel and burner control knobs Install LidComplete accessory installation To Extinguish LightingManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRefilling the LP tank Connecting the filled LP tankRemoval of the LP tank Mix soap and water Open the tank valve. Figure Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMWARNING Do not ignite burners while leak checking Weber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure MCAUTION Do not enlarge the burner ports when cleaningTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Flame, in conjunction with the smell of gas Problem Check Cure Burners burn with a yellow or orangeBarbecue temperature only reaches 250˚ to When burner is on HIGH. Flames do not run11-12 Parts List Page Page Final Word Thanks