Weber Spirit 500 series owner manual Crossover Ignition System Operations

Page 30

mWARNING: If the Spider Stopper Guards do not fit tightly, contact Weber-Stephen Customer Service.

mCAUTION: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. See Step“Check for gas leaks”.

Crossover Ignition System Operations

If the Crossover Ignition System fails to ignite the Front burner, light the Front burner with a match. If the Front burner lights with a match, then check the Crossover Ignition System.

■Check that both the white and black ignition wires are attached properly. Figure 20.

White wire

Black wire

Figure 20

■Check that the Crossover Ignition button pushes the igniter (button) down, and returns to the up position.

■Check to see if the igniter is loose in the frame.

Tighten if necessary; see Step “Install igniter” for correct procedure.

If the Crossover Ignition System still fails to light, contact Weber-Stephen Customer Service.

30

Image 30

Contents Spirit 500 Series MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents Storage For Installation in CanadaGeneral Instructions Operating areaAssembly Check package contentsStep Fuel scale assembly Five Flavorizer Bars Check contents of hardware packs Assemble wheel frame Assemble top frameContinue frame assembly Install tubing plugsAdd front panel Add cooking box Install manifold bracket Install tank panel assembly and frame connectorAdd fuel scale assembly Install igniterMCAUTION Do not remove adjustment wing nut from tank scale Set LP fuel scaleFill LP tank Check that all burner valves are off Connect LP tankMWARNING Do not ignite burners when leak checking Check for gas leaksInstall Flavorizer Bars and Cooking Grates Install the bottom trayAllowing grease to flow into the catch pan Install Lid Add tool holders, control panel and burner control knobsComplete accessory installation Lighting To ExtinguishManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseConnecting the filled LP tank Refilling the LP tankRemoval of the LP tank Mix soap and water Open the tank valve. Figure Safe handling tips for LP Gas Liquid Propane LP Tanks Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper Guards MWARNING Do not ignite burners while leak checking MCAUTION Do not enlarge the burner ports when cleaning General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations When burner is on HIGH. Flames do not run Problem Check Cure Burners burn with a yellow or orangeBarbecue temperature only reaches 250˚ to Flame, in conjunction with the smell of gas11-12 Parts List Page Page Final Word Thanks