8 | GAS INSTRUCTIONS |
|
WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.
5) Mix soap and water.
6) Turn on the cylinder valve.
7) Check for leaks by wetting the fitting with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fitting. Turn the gas back on and recheck with the soap and water solution.
If leak does not stop, Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. Do not use the barbecue.
8)When leak checking is complete, turn gas supply OFF at the source
and rinse connections with water.
REMOVE CONTROL PANEL AND BURNER CONTROL KNOBS
You will need: Phillips screwdriver.
1)Remove control knobs.
SILVER, GOLD AND PLATINUM C MODELS 2a) Unhook side burner from Cookbox Frame.
2)Remove screws with a Phillips screwdriver
3)Pull up igniter button until it sticks in the up position and remove control panel from grill.
4)Replace control panel when Leak Check is completed.
F<?I8E45 :B?75
C?4G<AH@5
F<?I8E6 :B?76
C?4G<AH@6
A