Weber 900 LP owner manual Install Flavorizer Bars and Cooking Grates, Install the bottom tray

Page 18

Step 17

Install Flavorizer Bars and Cooking Grates

You will need: five Flavorizer Bars and two cooking grates.

Set the Flavorizer Bars side to side in the cooking box. Figure 20.

Step 18

Install the bottom tray

You will need: bottom tray, catch pan holder, catch pan and one drip pan.

Figure 20

Set the cooking grates onto the ledges in the cooking box. Figure 21.

Finger grip on front

Front side of catch

edge of bottom tray

pan holder

Figure 22

Hook the ends of the catch pan holder into the hole in the bottom tray. Figure 23. The front of the catch pan holder must be on the same side as the finger grip of the bottom tray.

Finger grip

 

Figure 23

 

Slide the bottom tray onto the mounting rails under the

 

cooking box with finger grip toward you. Figure 24.

Figure 21

mCAUTION: Do not line bottom tray with aluminum foil.

 

 

It can cause grease fires by trapping the grease and not

 

allowing grease to flow into the catch pan.

Bottom tray

Figure 24

Put the foil drip pan into the catch pan.

Slide the catch pan into the catch pan holder with its finger grip towards you.

18

Image 18
Contents 900 LP Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents Storage For Installation in CanadaGeneral Instructions Operating areaAssembly Check package contentsStep REB Check contents of hardware packs Assemble wheel frame Assemble top frameContinue frame assembly Install tubing plugsAdd front panel Add cooking box Install manifold bracket Install tank panel assembly and frame connectorAdd fuel scale assembly Install igniterMCAUTION Do not remove adjustment wing nut from tank scale Set LP fuel scaleFill LP tank Check that all burner valves are off Connect LP tankMWARNING Do not ignite burners when leak checking Check for gas leaksSlide the bottom tray onto the mounting rails under Install Flavorizer Bars and Cooking GratesInstall the bottom tray Cooking box with finger grip toward you. FigureInstall Lid Add tool holders, control panel and burner control knobsInstall swing table MWARNING The load limit for the swing table is 30 poundsComplete accessory installation Lighting To ExtinguishManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseCast Iron Cooking Grates Connecting the filled LP tank Refilling the LP tankRemoval of the LP tank Male fitting Regulator Safe handling tips for LP Gas Liquid Propane LP TanksAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMWARNING Do not ignite burners while leak checking MCAUTION Do not enlarge the burner ports when cleaning General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Burner does not light, or flame is low in High position NCAUTION Do not line the bottom tray with aluminum foil11-12 65 51-53 56-57 Parts List Final Word Thanks