Weber 900 LP owner manual Crossover Ignition System Operations

Page 32

Crossover Ignition System Operations

If the Crossover Ignition System fails to ignite the Front burner, light the Front burner with a match. If the Front burner lights with a match, then check the Crossover Ignition System.

■Check that both the white and black ignition wires are attached properly. Figure 20.

White wire

Black wire

Figure 20

■Check that the Crossover Ignition button pushes the igniter (button) down, and returns to the up position.

■Check to see if the igniter is loose in the frame. Tighten if necessary; see Step “Install igniter” for correct procedure.

If the Crossover Ignition System still fails to light, contact Weber-Stephen Customer Service.

Image 32

Contents 900 LP Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents For Installation in Canada General InstructionsStorage Operating areaStep AssemblyCheck package contents REB Check contents of hardware packs Assemble wheel frame Assemble top frameAdd front panel Continue frame assemblyInstall tubing plugs Add cooking box Install manifold bracket Install tank panel assembly and frame connectorAdd fuel scale assembly Install igniterFill LP tank MCAUTION Do not remove adjustment wing nut from tank scaleSet LP fuel scale Check that all burner valves are off Connect LP tankMWARNING Do not ignite burners when leak checking Check for gas leaksInstall Flavorizer Bars and Cooking Grates Install the bottom traySlide the bottom tray onto the mounting rails under Cooking box with finger grip toward you. FigureInstall Lid Add tool holders, control panel and burner control knobsInstall swing table MWARNING The load limit for the swing table is 30 poundsComplete accessory installation Lighting To ExtinguishManual Lighting Periodic Cleaning CookingStorage and/or Nonuse Storage and/or NonuseCast Iron Cooking Grates Removal of the LP tank Connecting the filled LP tankRefilling the LP tank Male fitting Regulator Safe handling tips for LP Gas Liquid Propane LP Tanks MWARNING Do not ignite burners while leak checking Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper Guards General Maintenance Main Burner Cleaning ProcedureMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Burner does not light, or flame is low in High position NCAUTION Do not line the bottom tray with aluminum foil11-12 65 51-53 56-57 Parts List Final Word Thanks