Weber 5000 Series Annual Maintenance, Inspection and Cleaning of the Weber Spider Stopper Guards

Page 38

Annual Maintenance

After a period of nonuse we recommend that you perform the following maintenance procedures for your safety.

WARNING: Check hose before each use of barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber authorized replacement manifold assembly. Order from Weber-Stephen Products Co., Customer Service Center or authorized dealer.

■Inspect the burners for correct flame pattern. Clean if necessary, following the procedures outlined in the "General Maintenance" section of this manual.

■Check all gas fittings for leaks.

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

You will need: a soap and water solution and a rag or brush to apply it.

Make sure main burners are in the OFF position.

Make sure side burner is OFF. Remove valve control knob and screws. Remove enamel top.

Put the FlameCheck button on the FlameCheck valve.

To perform leak checks: open tank valve by turning the tank valve handwheel counterclockwise. Push the FlameCheck button down and hold down until leak checking is complete. This will allow gas to fill the hose and manifold.

WARNING: Do not ignite burners while leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows there is a leak.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

Check:

a)Hose to manifold connection. Figure 10 (a).

b)Regulator to tank connection. Figure 10 (b).

c)Manifold to side burner hose connection. Figure 10 (c).

WARNING: If there is a leak at connections (a) or (c), retighten the fitting with a wrench and recheck for leaks with soap and water solution.

If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE.

Contact Weber-Stephen Customer Service.

d)Side burner hose to side burner connection. Figure 10 (d).

e)Valves to manifold connections. Figure 10 (e).

f)Hose to regulator connection. Figure 10 (f).

WARNING: If there is a leak at connections (b), (d), (e) or (f), turn OFF the gas. DO NOT OPERATE

THE BARBECUE. Contact Weber-Stephen Customer Service.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

(a)(b)

(c)

(d)

(f)(e)

Figure 10

Inspection and Cleaning of the Weber Spider Stopper Guards

To inspect the Spider Stopper Guards, remove the control panel and look to see if they have dust or dirt on their outside surfaces. If they do, brush off the outside surface of the Spider Stopper Guards with a soft bristle brush (an old toothbrush for example). Check that there are no gaps in the Spider Stopper Guards’ seams or in the fit around the burners or valves. (See Section "General Maintenance".)

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents Storage For Installation in CanadaGeneral Instructions Operating areaStep AssemblyCheck package contents Page Page Check contents of hardware packs Assemble wheels Assemble frameContinue frame assembly Complete frame assemblyInsert casters Check the frame assemblyInstall left end panel Install the three back panels Install side burner locksAdd cooking box Install side burner Install manifold bracketInstall tank panel assembly Install right end panelAdd fuel scale Install bottom accessory traysInstall igniter Install left hand swing table Check that all burner valves are offInstall right hand swing table Hinge rod View from rear of barbecue Set LP fuel scale Fill LP tankConnect LP tank Check for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker Install cooking grates Install the bottom trayInstall the lid Install glass doors Secure side burnerComplete accessory installation Lighting To ExtinguishManual Lighting Side burner will only operate when the Front burner is lit Lighting the side burnerStorage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseUsing the Steam-N-Chips Smoker To use the Steam-N-Chips SmokerRefilling the LP tank Removal of the LP tankEngaged Safe handling tips for LP Gas Liquid Propane LP TanksAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsWeber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations FlameCheck Safety System Burner flame pattern is erratic. Flame is low When burner is on HIGH. Flames do not runBurner does not light, or flame is low in High position Resembles paint peelingProblem Check Cure Side burner does not light Side Burner TroubleshootingSide Burner Maintenance Flame is low in High positionPage 19-20 22-24 Parts List Final Word Thanks

5000 Series specifications

The Weber 5000 Series is a flagship line of outdoor grills that has garnered attention among barbecue enthusiasts and culinary professionals alike. Known for their superior engineering and innovative technologies, these grills are designed to deliver an exceptional grilling experience combined with robust functionality.

One standout feature of the Weber 5000 Series is its exceptional heat retention and distribution system. With a powerful gas cooking system, users can expect consistent temperatures across the grilling surface, ensuring that food is cooked evenly. This is achieved through high-performance burners that provide efficient heat output while minimizing fuel consumption, making it an eco-friendly choice as well.

The series is equipped with Weber's signature Flavorizer bars, which are designed to vaporize drippings and infuse the food with a rich, smoky flavor. These bars are strategically placed above the burners to catch and recycle fat and juices, allowing for a flavor-enhancing experience that is beloved by grillers. The series also features premium cooking grates made from stainless steel, which are not only durable but also provide great heat retention for the perfect sear.

Another highlight of the Weber 5000 Series is its integrated technology, including the iGrill app connectivity. This feature allows users to monitor their cooking progress via a smartphone, providing alerts when the food reaches the desired temperature. This smart technology takes the guesswork out of grilling, making it easier for anyone to achieve restaurant-quality results.

In terms of design, the Weber 5000 Series boasts a sleek and modern aesthetic, with options for various finishes that will complement any outdoor space. It includes a spacious cooking area, making it viable for both intimate family dinners and larger gatherings. Additional features such as side burners and built-in storage enhance the cooking experience and provide added convenience for outdoor meal preparation.

The Weber 5000 Series is built to last, constructed with weather-resistant materials to withstand the elements. This durability ensures that users can enjoy years of dependable grilling, making it a worthwhile investment for outdoor cooking enthusiasts.

Overall, the Weber 5000 Series stands out in the market for its combination of high-performance features, innovative technology, and thoughtful design. It is an excellent choice for those who appreciate quality grilling and are looking to elevate their outdoor cooking experience.
Top Page Image Contents