GAS INSTRUCTIONS
WARNING : The gas connections of your Summit® gas grill have been factory tested. We do however recommend that you leak check all gas connections before operating your Summit® gas grill.
Remove control panel
Part required: Phillips Screwdriver.
Remove the burner control knobs (1). The screws (2) need to be removed from the control panel (3) before the control panel is removed from the grill.
Remove the Front Panel by sliding the panel up and out of the slots.
(1)
(2)
(3)
Put your fingers under the front edge of the control panel and lift off.
Completely remove the control panel (4) from the cooking box assembly exposing the valves, burners, igniter, and manifold.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| (4) |
| (2) |
| |
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
CHECK FOR GAS LEAKS
DANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property.
WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.
Note - All
WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.
Make sure side burner is OFF.
To perform leak checks: open cylinder valve by turning the cylinder valve
7