Weber 41061 instruction manual Troubleshooting, Problem Check Cure

TROUBLESHOOTING

PROBLEM	CHECK	CURE
Burners burn with a yellow or orange flame, in	Inspect Weber® Insect/Spider screen for possible obstructions.	Clean Weber® Insect / Spider screen. (See Section
conjunction with the smell of gas.	(Blockage of holes.)	“Annual Maintenance”)
Burner does not light, or flame is low in	Is LP cylinder fuel low or empty? Does the burner light with a	Replace propane cylinder. If you can light the burner with a match, then check
HIGH position.	match?	the ignition system.
Experiencing flare-ups:	Are you preheating grill in the prescribed manner? Is the cooking	Burner on high for 10 minutes for preheating.Clean thoroughly. (See Section
CAUTION: Do not line the bottom tray with	grate heavily coated with burned-on grease?	“Cleaning”) Clean bottom tray.
aluminum foil.
Burner flame pattern is erratic. Flame is low	Is the bottom tray “dirty” and not allowing grease to flow into catch	Clean burner. (See Section “Annual Maintenance”.)
when burner is on HIGH. Flames do not run	pan? Is the burner clean?
the whole length of the burner tube.
Inside of lid appears to be “peeling.”	The lid is cast aluminum, not paint. It cannot “peel”. What you are	Clean thoroughly. (See Section “Cleaning”.)
(Resembles paint peeling.)	seeing is baked on grease that has turned to carbon and is flaking
	off. THIS IS NOT A DEFECT.
Burner does not light when igniter button is	Does burner light with a match?	If you can light burner with a match, refer to “IGNITION SYSTEMS
pushed.		OPERATION”.
Burner flame does not ignite completely	Are the burner ports clean and fully open?	Clean burner. (See Section “Annual Maintenance”.) Use a small paper clip to
around the burner tube.		unclog any dirty ports.

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your region using the contact information on our web site. Log onto www.weber.com®.

10