Weber 3000 owner manual Assembly, Step, Check package contents

Page 7

Assembly

Tools needed

Regular screwdriver

Phillips screwdriver

Hammer

7/16 inch or an adjustable wrench

Pliers

Step 1

Check package contents

Cooking box (assembly)

Lid (assembly)

® ®

Block of wood

Supplies needed

Your LP tank is shipped empty for safety. After setting the LP fuel scale you will need to fill it. (See Step "Fill LP tank.")

You will need a soap and water solution to check for gas leaks. (See Step "Check for gas leaks.")

Note - The hardware size of nuts, bolts and screws is given. For example "1/4-20 x 2 inch bolt" means a bolt 1/4 inch in diameter with 20 threads to the inch, 2 inches long. On a small screw for example, "6-32 x 1/2 inch screw" means a number 6 screw, with 32 threads to the inch, 1/2 inch long.

While we give much attention to our products, unfor tunately an occasional error may occur. If a part is missing, do not go back to the store. Call the Weber Customer Service Center toll free 1-800-446-1071to receive immediate assistance. Have your owner’s manual and serial number of the barbecue available for reference.

LP tank

LP tank filler adapter

Bottom tray

Work table

Two accessory trays

Swing table

7

Image 7
Contents Genesis 3000 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageCheck package contents AssemblyStep BER E W REB Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Add cooking box Install side burner locksAdd fuel scale Install tank panel assemblyCheck that all burner valves are off Install igniterInstall manifold bracket Install side burnerMWARNING Make sure gas supply is OFF Set LP fuel scale MCAUTION Do not remove adjustment wing nut from tank scaleFill LP tank Connect LP tank MWARNING Do not ignite burners while leak checking Check for gas leaksInstall the bottom tray Install Flavorizer Bars and Cooking GratesInstall tool holders, control panel and burner control knobs Install the lidSecure side burner Install swing tableMCAUTION Make sure both locks have snapped into place Notch to the front Slide bar View from front of barbecue Complete accessory installation To Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerStorage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRefilling the LP tank Connecting the filled LP tankRemoval of the LP tank Male fitting Regulator Collar Quick disconnect engaged Liquid Propane LP Tanks Safe handling tips for LP GasDate Tested Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall burners, reverse steps c through g Crossover Ignition System Operations Burner flame pattern is erratic. Flame is low When burner is on HIGH. Flames do not runBurner does not light, or flame is low in High position MCAUTION Do not line the bottom tray with aluminum foilSide Burner Maintenance Side Burner TroubleshootingPage 14-15 17-18 21-22 26 27 Parts List Final Word Thanks