Weber 39950 manual Install Wire LID Holder Assembly, Install TUCK-AWAY Frame Support

ASSEMBLY 9

8	INSTALL WIRE LID HOLDER ASSEMBLY
	You will need: Wire lid holder assembly and a 1/2 inch open-end or an adjustable wrench.

Remove 5/16-18 hex nut (1), 5/16 inch lock washer (2) and 7/8 inch aluminum washer (3) from each end of wire lid holder. Finger tighten remaining 5/16-18 hex nut (4).

Note - Bushings (5) should roll freely on wire lid holder.

Insert ends of wire lid holder through frame assembly and bowl on outside of wheel legs. Place 7/8 inch aluminum washer (3), 5/16 inch lock washer (2) then 5/16-18 hex nut (1) on each end of the wire lid holder and tighten.

(4)

(5)

(1)

(2)

(3)

9 INSTALL TUCK-AWAY FRAME SUPPORT

Swing Tuck-Away frame support up and set wire lid holder, with tabs centered (1), into slots in frame support.

(1)